UB Paderborn / Katalog / Suche / in CDI

1 – 25 von 137

Sortiert nach

Investigation of film solidification and binder migration during drying of Li-Ion battery anodes

Journal of power sources, 2016-06, Vol.318, p.210-219

2016

Link zum Volltext

Verfügbarkeit prüfen

Microstructure formation of lithium-ion battery electrodes during drying – An ex-situ study using cryogenic broad ion beam slope-cutting and scanning electron microscopy (Cryo-BIB-SEM)

Journal of power sources, 2017-03, Vol.345, p.97-107

2017

Link zum Volltext

Verfügbarkeit prüfen

Highly efficient polymer solar cells cast from non-halogenated xylene/anisaldehyde solution

Energy & environmental science, 2015-01, Vol.8 (9), p.2744-2752

2015

Link zum Volltext

Verfügbarkeit prüfen

CFD model of slot die coating for lithium-ion battery electrodes in 2D and 3D with load balanced dynamic mesh refinement enabled with a local-slip boundary condition in OpenFOAM

JCT research, 2023, Vol.20 (1), p.3-14

2023

Link zum Volltext

Verfügbarkeit prüfen

Drying of Lithium‐Ion Battery Anodes for Use in High‐Energy Cells: Influence of Electrode Thickness on Drying Time, Adhesion, and Crack Formation

Energy technology (Weinheim, Germany), 2019-11, Vol.7 (11), p.n/a

2019

Link zum Volltext

Verfügbarkeit prüfen

Critical Solutal Marangoni Number Correlation for Short-Scale Convective Instabilities in Drying Poly(vinyl acetate)-Methanol Thin Films

Polymers, 2021-08, Vol.13 (17), p.2955

2021

Link zum Volltext

Verfügbarkeit prüfen

Investigation of edge formation during the coating process of Li-ion battery electrodes

JCT research, 2022, Vol.19 (1), p.121-130

2022

Link zum Volltext

Verfügbarkeit prüfen

Slot-die processing of lithium-ion battery electrodes—Coating window characterization

Chemical engineering and processing, 2013-06, Vol.68, p.32-37

2013

Link zum Volltext

Verfügbarkeit prüfen

Comparison of large scale coating techniques for organic and hybrid films in polymer based solar cells

Chemical engineering and processing, 2013-06, Vol.68, p.38-44

2013

Link zum Volltext

Verfügbarkeit prüfen

Transient Three-Dimensional Flow Field Measurements by Means of 3D µPTV in Drying Poly(Vinyl Acetate)-Methanol Thin Films Subject to Short-Scale Marangoni Instabilities

Polymers, 2021-04, Vol.13 (8), p.1223

2021

Link zum Volltext

Verfügbarkeit prüfen

Moving through the Phase Diagram: Morphology Formation in Solution Cast Polymer–Fullerene Blend Films for Organic Solar Cells

ACS nano, 2011-11, Vol.5 (11), p.8579-8590

2011

Link zum Volltext

Verfügbarkeit prüfen

In memory of Professor Ernst-Ulrich Schlünder: An outstanding scientist in drying technology

Drying technology, 2022-04, Vol.40 (5), p.1027-1028

Schabel, Wilhelm

2022

Link zum Volltext

Verfügbarkeit prüfen

Influence of Particle Shape on the Drying Regime Maps for Platelike Particle–Polymer Composites

Langmuir, 2020-06, Vol.36 (22), p.6245-6253

2020

Link zum Volltext

Verfügbarkeit prüfen

Development of a water based process for stable conversion cathodes on the basis of FeF3

Journal of power sources, 2016-05, Vol.313, p.213-222

2016

Link zum Volltext

Verfügbarkeit prüfen

Formation of blade and slot die coated small molecule multilayers for OLED applications studied theoretically and by XPS depth profiling

AIP advances, 2016-06, Vol.6 (6), p.065108-065108-11

2016

Link zum Volltext

Verfügbarkeit prüfen

In Situ X-Ray Study of Drying-Temperature Influence on the Structural Evolution of Bulk-Heterojunction Polymer-Fullerene Solar Cells Processed by Doctor-Blading

Advanced energy materials, 2011-05, Vol.1 (3), p.363-367

2011

Link zum Volltext

Verfügbarkeit prüfen

Effect of Photovoltaic Polymer/Fullerene Blend Composition Ratio on Microstructure Evolution during Film Solidification Investigated in Real Time by X-ray Diffraction

Macromolecules, 2011-05, Vol.44 (10), p.3795-3800

2011

Link zum Volltext

Verfügbarkeit prüfen

Water sorption in poly(vinyl alcohol) membranes: An experimental and numerical study of solvent diffusion in a crosslinked polymer

Chemical engineering and processing, 2011-05, Vol.50 (5), p.543-550

2011

Link zum Volltext

Verfügbarkeit prüfen

Mass transport measurements in membranes by means of in situ Raman spectroscopy—First results of methanol and water profiles in fuel cell membranes

Journal of membrane science, 2007-10, Vol.303 (1), p.37-42

2007

Link zum Volltext

Verfügbarkeit prüfen

Using Hierarchically Structured, Nanoporous Particles as Building Blocks for NCM111 Cathodes

Nanomaterials (Basel, Switzerland), 2024-01, Vol.14 (2), p.134

2024

Link zum Volltext

Verfügbarkeit prüfen

Liquid film coating of small molecule OLEDs

Journal of Coatings Technology and Research, 2014-01, Vol.11 (1), p.75-81

2014

Link zum Volltext

Verfügbarkeit prüfen

Calibration Routine for Quantitative Three-Dimensional Flow Field Measurements in Drying Polymer Solutions Subject to Marangoni Convection

Colloids and interfaces, 2019-03, Vol.3 (1), p.39

2019

Link zum Volltext

Verfügbarkeit prüfen

Experimental investigation into battery electrode surfaces: The distribution of liquid at the surface and the emptying of pores during drying

Journal of colloid and interface science, 2017-05, Vol.494, p.22-31

2017

Link zum Volltext

Verfügbarkeit prüfen

Generation of strength in a drying film: How fracture toughness depends on dispersion properties

Physical review. E, 2017-02, Vol.95 (2-1), p.022610-022610, Article 022610

2017

Link zum Volltext

Verfügbarkeit prüfen

Determination of Concentration-Dependent Diffusion Coefficients in Polymer–Solvent Systems: Analysis of Concentration Profiles Measured by Raman Spectroscopy during Single Drying Experiments Excluding Boundary Conditions and Phase Equilibrium

Macromolecules, 2015-12, Vol.48 (23), p.8608-8614

2015

Link zum Volltext

Verfügbarkeit prüfen

1 – 25 von 137

Suche als RSS-Feed

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(130)
Mit Volltextzugriff
(136)

Publikationsform

Sprache

Englisch
(129)
Japanisch
(17)
Deutsch
(11)

Erscheinungsjahr

n.n

Thema

Science & Technology
(109)
Technology
(90)
Physical Sciences
(61)
Materials Science
(47)
Energy & Fuels
(43)
Chemistry
(39)
Drying
(33)
Lithium-Ion Batteries
(29)
Materials Science, Multidisciplinary
(27)
Engineering
(26)
Engineering, Chemical
(24)
Electrodes
(21)
Chemistry, Physical
(20)
Thin Films
(20)
Lithium
(19)
Electrochemistry
(17)
Materials Science, Coatings & Films
(17)
Diffusion
(16)
Exact Sciences And Technology
(16)
Surfaces And Interfaces
(16)

15 weitere anzeigen...

Weniger anzeigen...

Zeitschrift / Serie

5 weitere anzeigen...

Weniger anzeigen...

Neu hinzugefügt

... seit 90 Tagen
(3)

Menü

Weitere Dienste

Einstellungen

Investigation of film solidification and binder migration during drying of Li-Ion battery anodes

Microstructure formation of lithium-ion battery electrodes during drying – An ex-situ study using cryogenic broad ion beam slope-cutting and scanning electron microscopy (Cryo-BIB-SEM)

Highly efficient polymer solar cells cast from non-halogenated xylene/anisaldehyde solution

CFD model of slot die coating for lithium-ion battery electrodes in 2D and 3D with load balanced dynamic mesh refinement enabled with a local-slip boundary condition in OpenFOAM

Drying of Lithium‐Ion Battery Anodes for Use in High‐Energy Cells: Influence of Electrode Thickness on Drying Time, Adhesion, and Crack Formation

Critical Solutal Marangoni Number Correlation for Short-Scale Convective Instabilities in Drying Poly(vinyl acetate)-Methanol Thin Films

Investigation of edge formation during the coating process of Li-ion battery electrodes

Slot-die processing of lithium-ion battery electrodes—Coating window characterization

Comparison of large scale coating techniques for organic and hybrid films in polymer based solar cells

Transient Three-Dimensional Flow Field Measurements by Means of 3D µPTV in Drying Poly(Vinyl Acetate)-Methanol Thin Films Subject to Short-Scale Marangoni Instabilities

Moving through the Phase Diagram: Morphology Formation in Solution Cast Polymer–Fullerene Blend Films for Organic Solar Cells

In memory of Professor Ernst-Ulrich Schlünder: An outstanding scientist in drying technology

Influence of Particle Shape on the Drying Regime Maps for Platelike Particle–Polymer Composites

Development of a water based process for stable conversion cathodes on the basis of FeF3

Formation of blade and slot die coated small molecule multilayers for OLED applications studied theoretically and by XPS depth profiling

In Situ X-Ray Study of Drying-Temperature Influence on the Structural Evolution of Bulk-Heterojunction Polymer-Fullerene Solar Cells Processed by Doctor-Blading

Effect of Photovoltaic Polymer/Fullerene Blend Composition Ratio on Microstructure Evolution during Film Solidification Investigated in Real Time by X-ray Diffraction

Water sorption in poly(vinyl alcohol) membranes: An experimental and numerical study of solvent diffusion in a crosslinked polymer

Mass transport measurements in membranes by means of in situ Raman spectroscopy—First results of methanol and water profiles in fuel cell membranes

Using Hierarchically Structured, Nanoporous Particles as Building Blocks for NCM111 Cathodes

Liquid film coating of small molecule OLEDs

Calibration Routine for Quantitative Three-Dimensional Flow Field Measurements in Drying Polymer Solutions Subject to Marangoni Convection

Experimental investigation into battery electrode surfaces: The distribution of liquid at the surface and the emptying of pores during drying

Generation of strength in a drying film: How fracture toughness depends on dispersion properties

Determination of Concentration-Dependent Diffusion Coefficients in Polymer–Solvent Systems: Analysis of Concentration Profiles Measured by Raman Spectroscopy during Single Drying Experiments Excluding Boundary Conditions and Phase Equilibrium

Suchergebnisse filtern