Sie befinden Sich nicht im Netzwerk der Universität Paderborn. Der Zugriff auf elektronische Ressourcen ist gegebenenfalls nur via VPN oder Shibboleth (DFN-AAI) möglich. mehr Informationen...
Surface modification of polyethylene by medium pressure microplasma generator
Ist Teil von
Surface engineering, 2011-03, Vol.27 (2), p.80-85
Ort / Verlag
London, England: Taylor & Francis
Erscheinungsjahr
2011
Link zum Volltext
Quelle
Taylor & Francis Online Single Subscriptions
Beschreibungen/Notizen
Polyethylene surface modification studies were performed in a new microplasma source using O
2
and N
2
gases. The degree of modification of polyethylene surface was qualitatively investigated through water contact angle measurements using distilled water. The influence of the plasma discharge parameters, such as gas nature, gas flow, power and exposure time, over the polyethylene contact angle was investigated. The obtained results indicate a decrease of the contact angle from 100° (for untreated sample) to 22·9°, when N
2
plasma was used for 40 s and discharge power >2 W. The surface morphology of the samples was examined by atomic force microscope and a smoothing effect after the plasma treatment was found. These results are very promising because of the experimental set-up which requires medium vacuum, exhibit low process temperature (50-100°C) leaving the surface intact. Other advantages are the very short processing time (60 s) and applicability to large area substrates.