UB Paderborn / Katalog / Suche / in CDI

Sortiert nach

Einfacher Volltextzugriff von (fast) überall

Installieren Sie die LibKey Nomad-Browsererweiterung und erhalten Sie von vielen Webseiten einfachen Zugriff auf lizenzierte Volltexte oder Open Access Publikationen. Mehr erfahren...

Horizontal annular flow through orifice studied by X-ray microtomography

Experiments in fluids, 2021, Vol.62 (1), Article 5

2021

Volltextzugriff (PDF)

Comparative study of ultrafast X-ray tomography and wire-mesh sensors for vertical gas–liquid pipe flows

Flow measurement and instrumentation, 2017-03, Vol.53, p.95-106

2017

Volltextzugriff (PDF)

Velocity measurement for two-phase flows based on ultrafast X-ray tomography

Flow measurement and instrumentation, 2015-12, Vol.46, p.196-203

2015

Volltextzugriff (PDF)

Influence of the Lagrangian Integral Time Scale Estimation in the Near Wall Region on Particle Deposition

Journal of fluids engineering, 2012-07, Vol.134 (7)

2012

Volltextzugriff (PDF)

Experimental Investigation of Horizontal Gas–Liquid Stratified and Annular Flow Using Wire-Mesh Sensor

Journal of fluids engineering, 2014-12, Vol.136 (12)

2014

Volltextzugriff (PDF)

Analysis of the influence of swirling flow on the boiling heat transfer characteristics of two-phase flow

International journal of heat and mass transfer, 2024-04, Vol.221, p.125075, Article 125075

2024

Volltextzugriff (PDF)

Multi-objective optimization of fractal-tree microchannels in a rectangular heat sink by a distributed-adaptive genetic algorithm

International journal of heat and mass transfer, 2023-12, Vol.217, p.124672, Article 124672

2023

Volltextzugriff (PDF)

Thermal and flow performance of tilted oval tubes with novel fin designs

International journal of heat and mass transfer, 2020-06, Vol.153, p.119621, Article 119621

2020

Volltextzugriff (PDF)

CFD-modelling of boiling in a heated pipe including flow pattern transition

Applied thermal engineering, 2022-03, Vol.204, p.117962, Article 117962

2022

Volltextzugriff (PDF)

Experimental study on the air-side thermal-flow performance of additively manufactured heat exchangers with novel fin designs

International journal of thermal sciences, 2019-12, Vol.146, p.106074, Article 106074

2019

Volltextzugriff (PDF)

Modelling and simulation of flow boiling with an Eulerian-Eulerian approach and integrated models for bubble dynamics and temperature-dependent heat partitioning

International journal of thermal sciences, 2021-03, Vol.161, p.106709, Article 106709

2021

Volltextzugriff (PDF)

An experimental investigation on the air-side heat transfer and flow resistance of finned short oval tubes at different tube tilt angles

International journal of thermal sciences, 2019-06, Vol.140, p.225-237

2019

Volltextzugriff (PDF)

An Experimental Study on the Gas Entrainment in Horizontally and Vertically Installed Centrifugal Pumps

Journal of fluids engineering, 2016-09, Vol.138 (9)

2016

Volltextzugriff (PDF)

The role of microlayer for bubble sliding in nucleate boiling: A new viewpoint for heat transfer enhancement via surface engineering

International journal of heat and mass transfer, 2020-03, Vol.149, p.119239, Article 119239

2020

Volltextzugriff (PDF)

Direct numerical simulation of microlayer formation and evaporation underneath a growing bubble driven by the local temperature gradient in nucleate boiling

International journal of thermal sciences, 2023-11, Vol.193, p.108551, Article 108551

2023

Volltextzugriff (PDF)

Air-side heat transfer and flow characteristics of additively manufactured finned tubes in staggered arrangement

International journal of thermal sciences, 2021-03, Vol.161, p.106752, Article 106752

2021

Volltextzugriff (PDF)

Evaluation of the microlayer contribution to bubble growth in horizontal pool boiling with a mechanistic model that considers dynamic contact angle and base expansion

The International journal of heat and fluid flow, 2018-08, Vol.72, p.274-287

2018

Volltextzugriff (PDF)

Quantitative prediction of critical heat flux initiation in pool and flow boiling

International journal of thermal sciences, 2018-03, Vol.125, p.121-131

2018

Volltextzugriff (PDF)

An experimental study of boiling two-phase flow in a vertical rod bundle with a spacer grid-Part 2: Effects of vane angle

Experimental thermal and fluid science, 2023-11, Vol.149, p.111000, Article 111000

2023

Volltextzugriff (PDF)

An experimental study of boiling two-phase flow in a vertical rod bundle with a spacer grid. Part 1: Effects of mass flux and heat flux

Experimental thermal and fluid science, 2023-07, Vol.145, p.110903, Article 110903

2023

Volltextzugriff (PDF)

Editorial for special issue on process tomography in flow measurement and instrumentation

Flow measurement and instrumentation, 2017-03, Vol.53, p.1-3

Hampel, Uwe

2017

Volltextzugriff (PDF)

Experimental study of the natural convection heat transfer performance for finned oval tubes at different tube tilt angles

Experimental thermal and fluid science, 2019-07, Vol.105, p.100-108

2019

Volltextzugriff (PDF)

Investigation of mass transfer in milli-channels using high-resolution microfocus X-ray imaging

International journal of heat and mass transfer, 2016-02, Vol.93, p.653-664

2016

Volltextzugriff (PDF)

Application of gamma-ray computed tomography for the analysis of gas holdup distributions in centrifugal pumps

Flow measurement and instrumentation, 2015-12, Vol.46, p.262-267

2015

Volltextzugriff (PDF)

Flow rate measurement in flows with asymmetric velocity profiles by means of distributed thermal anemometry

Flow measurement and instrumentation, 2019-08, Vol.68, p.101570, Article 101570

2019

Volltextzugriff (PDF)

1 – 25 von 42

Suche als RSS-Feed

Aktive Filter

SpracheDeutsch

ThemaEngineering, Mechanical

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(41)
Mit Volltextzugriff
(38)

Publikationsform

Artikel
(42)

Sprache

Erscheinungsjahr

n.n

Thema

14 weitere anzeigen...

Weniger anzeigen...

Kollektion

3 weitere anzeigen...

Weniger anzeigen...

Menü

Weitere Dienste

Einstellungen

Horizontal annular flow through orifice studied by X-ray microtomography

Comparative study of ultrafast X-ray tomography and wire-mesh sensors for vertical gas–liquid pipe flows

Velocity measurement for two-phase flows based on ultrafast X-ray tomography

Influence of the Lagrangian Integral Time Scale Estimation in the Near Wall Region on Particle Deposition

Experimental Investigation of Horizontal Gas–Liquid Stratified and Annular Flow Using Wire-Mesh Sensor

Analysis of the influence of swirling flow on the boiling heat transfer characteristics of two-phase flow

Multi-objective optimization of fractal-tree microchannels in a rectangular heat sink by a distributed-adaptive genetic algorithm

Thermal and flow performance of tilted oval tubes with novel fin designs

CFD-modelling of boiling in a heated pipe including flow pattern transition

Experimental study on the air-side thermal-flow performance of additively manufactured heat exchangers with novel fin designs

Modelling and simulation of flow boiling with an Eulerian-Eulerian approach and integrated models for bubble dynamics and temperature-dependent heat partitioning

An experimental investigation on the air-side heat transfer and flow resistance of finned short oval tubes at different tube tilt angles

An Experimental Study on the Gas Entrainment in Horizontally and Vertically Installed Centrifugal Pumps

The role of microlayer for bubble sliding in nucleate boiling: A new viewpoint for heat transfer enhancement via surface engineering

Direct numerical simulation of microlayer formation and evaporation underneath a growing bubble driven by the local temperature gradient in nucleate boiling

Air-side heat transfer and flow characteristics of additively manufactured finned tubes in staggered arrangement

Evaluation of the microlayer contribution to bubble growth in horizontal pool boiling with a mechanistic model that considers dynamic contact angle and base expansion

Quantitative prediction of critical heat flux initiation in pool and flow boiling

An experimental study of boiling two-phase flow in a vertical rod bundle with a spacer grid-Part 2: Effects of vane angle

An experimental study of boiling two-phase flow in a vertical rod bundle with a spacer grid. Part 1: Effects of mass flux and heat flux

Editorial for special issue on process tomography in flow measurement and instrumentation

Experimental study of the natural convection heat transfer performance for finned oval tubes at different tube tilt angles

Investigation of mass transfer in milli-channels using high-resolution microfocus X-ray imaging

Application of gamma-ray computed tomography for the analysis of gas holdup distributions in centrifugal pumps

Flow rate measurement in flows with asymmetric velocity profiles by means of distributed thermal anemometry

Aktive Filter

Suchergebnisse filtern