UB Paderborn / Katalog / Suche / in CDI

Sortiert nach

Einfacher Volltextzugriff von (fast) überall

Installieren Sie die LibKey Nomad-Browsererweiterung und erhalten Sie von vielen Webseiten einfachen Zugriff auf lizenzierte Volltexte oder Open Access Publikationen. Mehr erfahren...

Microstructure and mechanical properties of inertia friction welded joints between high-strength low-alloy steel and medium carbon steel

Journal of materials processing technology, 2020-12, Vol.286, p.116811, Article 116811

2020

Volltextzugriff (PDF)

Enhancing strength-ductility synergy in an extruded Al-Cu-Li-Mg-Ag alloy via homogeneous GP zones and dislocation configuration

Materials & design, 2024-03, Vol.239, p.112766, Article 112766

2024

Volltextzugriff (PDF)

Effects of heat treatment and pre-stretching on the mechanical properties and microstructure evolution of extruded 2050 Al–Cu–Li alloy

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2022-06, Vol.845, p.143236, Article 143236

2022

Volltextzugriff (PDF)

New insight into enhancing the comprehensive mechanical performance in non-stretched Al-Cu-Li-(Mg)-(Ag)-Mn-Zr alloys

Materials letters, 2024-04, Vol.360, p.135899, Article 135899

2024

Volltextzugriff (PDF)

Influence of Cu addition on hot tearing susceptibility and fluidity of Al-Li-Cu alloys: Experimental investigation, criterion prediction and simulation assessment

Journal of alloys and compounds, 2023-12, Vol.969, p.172301, Article 172301

2023

Volltextzugriff (PDF)

Regulation of precipitation behavior among T1, S', and θ' phases in Al–Cu–Li-(Mg–Ag) alloys by optimizing Ag/Mg ratios

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2023-06, Vol.876, p.145158, Article 145158

2023

Volltextzugriff (PDF)

Achieving superior strength-ductility balance by tailoring dislocation density and shearable GP zone of extruded Al-Cu-Li alloy

International journal of plasticity, 2024-11, Vol.182, p.104135, Article 104135

2024

Volltextzugriff (PDF)

Effects of post heat treatment on the microstructure and mechanical properties of selective laser melted AlSi10Mg alloys

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2024-03, Vol.894, p.146195, Article 146195

2024

Volltextzugriff (PDF)

Optimizing recrystallization behavior induced by Mn micro-alloying for reduced anisotropy in rolled Al–Cu–Li alloys

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2024-09, Vol.909, p.146831, Article 146831

2024

Volltextzugriff (PDF)

Microstructure and mechanical properties of cast Al-Li-Mg alloy: Role of Cu addition and heat treatment

Journal of materials science & technology, 2024-11, Vol.199, p.1-16

2024

Volltextzugriff (PDF)

Achieving low hot tearing susceptibility in high-strength cast Al–Li alloys: Experimental investigation and simulation assessment

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2024-09, Vol.910, p.146901, Article 146901

2024

Volltextzugriff (PDF)

Selective laser melting of a novel Al-Si-Fe-Mn-Ni alloy with superior mechanical properties at both room and elevated temperatures: Influence of processing parameters and heat treatment

Materials characterization, 2024-08, Vol.214, p.114098, Article 114098

2024

Volltextzugriff (PDF)

Effect of Li Content on Hot-Tearing Susceptibility of Ternary Al-Cu-Li Alloys: Experimental Investigation, Criterion Prediction, and Simulation Assessment

Metallurgical and materials transactions. A, Physical metallurgy and materials science, 2023-12, Vol.54 (12), p.4850-4867

2023

Volltextzugriff (PDF)

Effect of Thickness on the Thermal Conductivity and Microstructure of Die-Cast AZ91D Magnesium Alloy

Metallurgical and materials transactions. A, Physical metallurgy and materials science, 2019-12, Vol.50 (12), p.5969-5976

2019

Volltextzugriff (PDF)

Microstructure and Mechanical Properties of Inertia‐Friction‐Welded Fe–Cr–Ni–Mo High‐Strength Steel

Steel research international, 2020-09, Vol.91 (9), p.n/a

2020

Volltextzugriff (PDF)

Point-ln-Polyhedra Test with Direct Handling of Degeneracies

地球空间信息科学学报：英文版, 2011, Vol.14 (2), p.91-97

CUI Shulin ZHANG Shuqing CHEN Xuanxi PANG Zhenping FU Xiaoyang ZHANG Xu

2011

Volltextzugriff (PDF)

Mass spectrometry-based techniques for single-cell analysis

Analyst (London), 2023-08, Vol.148 (16), p.369-377

2023

Volltextzugriff (PDF)

2.3-µm single-frequency Tm: ZBLAN fiber amplifier with output power of 1.41 W

Optics express, 2023-11, Vol.31 (24), p.40991-40999

2023

Volltextzugriff (PDF)

Dual-wavelength single-frequency Tm:ZBLAN fiber amplifier operating at 1.94 and 2.33 μm

Optics and laser technology, 2025-02, Vol.181, p.111701, Article 111701

2025

Volltextzugriff (PDF)

Construction of a double-responsive modified guar gum nanoparticles and its application in oral insulin administration

Colloids and surfaces, B, Biointerfaces, 2022-12, Vol.220, p.112858-112858, Article 112858

2022

Volltextzugriff (PDF)

Correlated topological flat bands in rhombohedral graphite

Proceedings of the National Academy of Sciences - PNAS, 2024-10, Vol.121 (43)

2024

Volltextzugriff (PDF)

O2−-V5+ charge transfer band, chemical bond parameters and R/O of Eu3+ doped Ca(VO3)2 and Ca3(VO4)2: A comparable study

Journal of alloys and compounds, 2017-12, Vol.726, p.121-131

2017

Volltextzugriff (PDF)

Fitted peaks data of O2−–V5+ charge transfer bands and R/O data of Eu3+ doped Ca(VO3)2 and Ca3(VO4)2

Data in brief, 2018-04, Vol.17, p.1153-1157

2018

Volltextzugriff (PDF)

Fitted peaks data of O 2- -V 5+ charge transfer bands and R/O data of Eu 3+ doped Ca(VO 3 ) 2 and Ca 3 (VO 4 ) 2

Data in brief, 2018-04, Vol.17, p.1153

2018

Volltextzugriff (PDF)

Point-in-polyhedra test with direct handling of degeneracies

Geo-spatial information science, 2011-01, Vol.14 (2), p.91-97

2011

Volltextzugriff (PDF)

1 – 25 von 25

Suche als RSS-Feed

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(25)
Mit Volltextzugriff
(24)

Publikationsform

Artikel
(25)

Sprache

Englisch
(25)

Erscheinungsjahr

n.n

Neu hinzugefügt

... seit 30 Tagen
(1)
... seit 90 Tagen
(3)

Menü

Weitere Dienste

Einstellungen

Microstructure and mechanical properties of inertia friction welded joints between high-strength low-alloy steel and medium carbon steel

Enhancing strength-ductility synergy in an extruded Al-Cu-Li-Mg-Ag alloy via homogeneous GP zones and dislocation configuration

Effects of heat treatment and pre-stretching on the mechanical properties and microstructure evolution of extruded 2050 Al–Cu–Li alloy

New insight into enhancing the comprehensive mechanical performance in non-stretched Al-Cu-Li-(Mg)-(Ag)-Mn-Zr alloys

Influence of Cu addition on hot tearing susceptibility and fluidity of Al-Li-Cu alloys: Experimental investigation, criterion prediction and simulation assessment

Regulation of precipitation behavior among T1, S', and θ' phases in Al–Cu–Li-(Mg–Ag) alloys by optimizing Ag/Mg ratios

Achieving superior strength-ductility balance by tailoring dislocation density and shearable GP zone of extruded Al-Cu-Li alloy

Effects of post heat treatment on the microstructure and mechanical properties of selective laser melted AlSi10Mg alloys

Optimizing recrystallization behavior induced by Mn micro-alloying for reduced anisotropy in rolled Al–Cu–Li alloys

Microstructure and mechanical properties of cast Al-Li-Mg alloy: Role of Cu addition and heat treatment

Achieving low hot tearing susceptibility in high-strength cast Al–Li alloys: Experimental investigation and simulation assessment

Selective laser melting of a novel Al-Si-Fe-Mn-Ni alloy with superior mechanical properties at both room and elevated temperatures: Influence of processing parameters and heat treatment

Effect of Li Content on Hot-Tearing Susceptibility of Ternary Al-Cu-Li Alloys: Experimental Investigation, Criterion Prediction, and Simulation Assessment

Effect of Thickness on the Thermal Conductivity and Microstructure of Die-Cast AZ91D Magnesium Alloy

Microstructure and Mechanical Properties of Inertia‐Friction‐Welded Fe–Cr–Ni–Mo High‐Strength Steel

Point-ln-Polyhedra Test with Direct Handling of Degeneracies

Mass spectrometry-based techniques for single-cell analysis

2.3-µm single-frequency Tm: ZBLAN fiber amplifier with output power of 1.41 W

Dual-wavelength single-frequency Tm:ZBLAN fiber amplifier operating at 1.94 and 2.33 μm

Construction of a double-responsive modified guar gum nanoparticles and its application in oral insulin administration

Correlated topological flat bands in rhombohedral graphite

O2−-V5+ charge transfer band, chemical bond parameters and R/O of Eu3+ doped Ca(VO3)2 and Ca3(VO4)2: A comparable study

Fitted peaks data of O2−–V5+ charge transfer bands and R/O data of Eu3+ doped Ca(VO3)2 and Ca3(VO4)2

Fitted peaks data of O 2- -V 5+ charge transfer bands and R/O data of Eu 3+ doped Ca(VO 3 ) 2 and Ca 3 (VO 4 ) 2

Point-in-polyhedra test with direct handling of degeneracies

Suchergebnisse filtern