UB Paderborn / Katalog / Suche / in CDI

Sortiert nach

Microstructure and anisotropic mechanical behavior of the high-strength and ductility AZ91 Mg alloy processed by hot extrusion and multi-pass RD-ECAP

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2020-04, Vol.780, p.139191, Article 139191

2020

Link zum Volltext

Verfügbarkeit prüfen

Achieving excellent ductility in high-strength Mg-10.6Gd-2 Ag alloy via equal channel angular pressing

Journal of alloys and compounds, 2020-03, Vol.817, p.152688, Article 152688

2020

Link zum Volltext

Verfügbarkeit prüfen

Preparation of a high strength and high ductility Mg-6Zn alloy wire by combination of ECAP and hot drawing

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2019-01, Vol.739, p.513-518

2019

Link zum Volltext

Verfügbarkeit prüfen

Pooled Safety Analysis of Evolocumab in Over 6000 Patients From Double-Blind and Open-Label Extension Studies

Circulation (New York, N.Y.), 2017-05, Vol.135 (19), p.1819-1831

2017

Link zum Volltext

Verfügbarkeit prüfen

Recent progress of novel biodegradable zinc alloys: from the perspective of strengthening and toughening

Journal of materials research and technology, 2022-03, Vol.17, p.244-269

2022

Link zum Volltext

Verfügbarkeit prüfen

Hardening response and precipitation behavior of Al–7%Si–0.3%Mg alloy in a pre-aging process

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2013-01, Vol.560, p.811-816

2013

Link zum Volltext

Verfügbarkeit prüfen

Effect of minor addition of vanadium on mechanical properties and microstructures of as-extruded near eutectic Al–Si–Mg alloy

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2014-04, Vol.602, p.41-48

2014

Link zum Volltext

Verfügbarkeit prüfen

Dynamic precipitation of Mg2Si induced by temperature and strain during hot extrusion and its impact on microstructure and mechanical properties of near eutectic Al–Si–Mg–V alloy

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2014-09, Vol.614, p.162-170

2014

Link zum Volltext

Verfügbarkeit prüfen

Effect of Si Content on Dynamic Recrystallization of Al-Si-Mg Alloys During Hot Extrusion

Journal of materials science & technology, 2014-12, Vol.30 (12), p.1271-1277

2014

Link zum Volltext

Verfügbarkeit prüfen

Design, synthesis, and evaluation of cyclic C7-bridged monocarbonyl curcumin analogs containing an o -methoxy phenyl group as potential agents against gastric cancer

Journal of enzyme inhibition and medicinal chemistry, 2024-12, Vol.39 (1), p.2314233-2314233

2024

Link zum Volltext

Verfügbarkeit prüfen

Developing high-strength ultrafine-grained pure Al via large-pass ECAP and post cryo-rolling

Journal of materials research and technology, 2021-11, Vol.15, p.2419-2428

2021

Link zum Volltext

Verfügbarkeit prüfen

Recent progress of Mg–Sn based alloys: the relationship between aging response and mechanical performance

Journal of materials research and technology, 2022-11, Vol.21, p.186-211

2022

Link zum Volltext

Verfügbarkeit prüfen

Neurodevelopmental status and adaptive behavior of pediatric patients with mucopolysaccharidosis II: a longitudinal observational study

Orphanet journal of rare diseases, 2023-11, Vol.18 (1), p.1-357, Article 357

2023

Link zum Volltext

Verfügbarkeit prüfen

Effect of eutectic Si size on the flow behavior and hot processing map of near eutectic Al–Si alloys

Journal of materials research and technology, 2021-11, Vol.15, p.5694-5705

2021

Link zum Volltext

Verfügbarkeit prüfen

A bimodal grain structured Zn–0.5Ag–0.2Mg alloy with high strength and ductility achieved through combined ECAP and cold rolling

Journal of materials research and technology, 2023-05, Vol.24, p.3222-3234

2023

Link zum Volltext

Verfügbarkeit prüfen

Effect of Homogenization Temperature on Microstructure and Conductivity of Al-Mg-Si-Ce Alloy

Journal of materials engineering and performance, 2016-07, Vol.25 (7), p.2720-2726

2016

Link zum Volltext

Verfügbarkeit prüfen

Pre-precipitating promoted by microshear bands effectively circumvents strength-ductility trade-off of RT-rolled Al–6Zn–1Mg alloy

Journal of materials research and technology, 2024-01, Vol.28, p.2767-2777

2024

Link zum Volltext

Verfügbarkeit prüfen

RT ECAP and rolling bestow high strength and good ductility on a low lithium aluminum alloy

Journal of materials research and technology, 2023-07, Vol.25, p.5561-5574

2023

Link zum Volltext

Verfügbarkeit prüfen

Grain refinement mechanism and mechanical properties of wrought Zn-0.1Mg-0.02Mn alloys by rolling at different reductions

Journal of materials research and technology, 2023-07, Vol.25, p.6263-6274

2023

Link zum Volltext

Verfügbarkeit prüfen

Promoted Anodizing Reaction and Enhanced Coating Performance of Al–11Si Alloy: The Role of an Equal-Channel-Angular-Pressed Substrate

Materials, 2019-10, Vol.12 (19), p.3255

2019

Link zum Volltext

Verfügbarkeit prüfen

A Phase I Randomized Trial of Once‐Daily Versus Twice‐Daily Recombinant Human Parathyroid Hormone (1‐84) for Hypoparathyroidism

JBMR plus, 2023-07, Vol.7 (7), p.e10758-n/a

2023

Link zum Volltext

Verfügbarkeit prüfen

High Mechanical Properties of AZ91 Mg Alloy Processed by Equal Channel Angular Pressing and Rolling

Metals (Basel ), 2019-04, Vol.9 (4), p.386

2019

Link zum Volltext

Verfügbarkeit prüfen

Enhanced high-cycle fatigue strength of Al–12Si–4Cu-1.2Mn-T6 cast aluminum alloy at room temperature and 350 C

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2021-09, Vol.825, p.141917, Article 141917

2021

Link zum Volltext

Verfügbarkeit prüfen

Cooperative Effect of Li Content and Equal-Channel Angular Pressing on Microstructure and Mechanical Properties of Al-Mg-Li Alloy

Metals (Basel ), 2019, Vol.9 (8), p.840

2019

Link zum Volltext

Verfügbarkeit prüfen

Joint effect of micro-sized Si particles and nano-sized dispersoids on the flow behavior and dynamic recrystallization of near-eutectic Al–Si based alloys during hot compression

Journal of alloys and compounds, 2021-03, Vol.856, p.158072, Article 158072

2021

Link zum Volltext

Verfügbarkeit prüfen

1 – 25 von 260

Suche als RSS-Feed

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(237)
Mit Volltextzugriff
(248)

Publikationsform

Sprache

Erscheinungsjahr

n.n

Thema

Science & Technology
(193)
Life Sciences & Biomedicine
(90)
Technology
(82)
Materials Science
(58)
Materials Science, Multidisciplinary
(53)
Physical Sciences
(51)
Humans
(43)
Metallurgy & Metallurgical Engineering
(40)
Chemistry
(33)
Science & Technology - Other Topics
(29)
Engineering
(25)
Microstructure
(24)
Nanoscience & Nanotechnology
(23)
Mechanical Properties
(22)
Animals
(21)
Female
(21)
Male
(19)
Aluminum Base Alloys
(15)
Environmental Sciences
(15)
Environmental Sciences & Ecology
(15)

15 weitere anzeigen...

Weniger anzeigen...

Neu hinzugefügt

... seit 90 Tagen
(5)

Menü

Weitere Dienste

Einstellungen

Microstructure and anisotropic mechanical behavior of the high-strength and ductility AZ91 Mg alloy processed by hot extrusion and multi-pass RD-ECAP

Achieving excellent ductility in high-strength Mg-10.6Gd-2 Ag alloy via equal channel angular pressing

Preparation of a high strength and high ductility Mg-6Zn alloy wire by combination of ECAP and hot drawing

Pooled Safety Analysis of Evolocumab in Over 6000 Patients From Double-Blind and Open-Label Extension Studies

Recent progress of novel biodegradable zinc alloys: from the perspective of strengthening and toughening

Hardening response and precipitation behavior of Al–7%Si–0.3%Mg alloy in a pre-aging process

Effect of minor addition of vanadium on mechanical properties and microstructures of as-extruded near eutectic Al–Si–Mg alloy

Dynamic precipitation of Mg2Si induced by temperature and strain during hot extrusion and its impact on microstructure and mechanical properties of near eutectic Al–Si–Mg–V alloy

Effect of Si Content on Dynamic Recrystallization of Al-Si-Mg Alloys During Hot Extrusion

Design, synthesis, and evaluation of cyclic C7-bridged monocarbonyl curcumin analogs containing an o -methoxy phenyl group as potential agents against gastric cancer

Developing high-strength ultrafine-grained pure Al via large-pass ECAP and post cryo-rolling

Recent progress of Mg–Sn based alloys: the relationship between aging response and mechanical performance

Neurodevelopmental status and adaptive behavior of pediatric patients with mucopolysaccharidosis II: a longitudinal observational study

Effect of eutectic Si size on the flow behavior and hot processing map of near eutectic Al–Si alloys

A bimodal grain structured Zn–0.5Ag–0.2Mg alloy with high strength and ductility achieved through combined ECAP and cold rolling

Effect of Homogenization Temperature on Microstructure and Conductivity of Al-Mg-Si-Ce Alloy

Pre-precipitating promoted by microshear bands effectively circumvents strength-ductility trade-off of RT-rolled Al–6Zn–1Mg alloy

RT ECAP and rolling bestow high strength and good ductility on a low lithium aluminum alloy

Grain refinement mechanism and mechanical properties of wrought Zn-0.1Mg-0.02Mn alloys by rolling at different reductions

Promoted Anodizing Reaction and Enhanced Coating Performance of Al–11Si Alloy: The Role of an Equal-Channel-Angular-Pressed Substrate

A Phase I Randomized Trial of Once‐Daily Versus Twice‐Daily Recombinant Human Parathyroid Hormone (1‐84) for Hypoparathyroidism

High Mechanical Properties of AZ91 Mg Alloy Processed by Equal Channel Angular Pressing and Rolling

Enhanced high-cycle fatigue strength of Al–12Si–4Cu-1.2Mn-T6 cast aluminum alloy at room temperature and 350 C

Cooperative Effect of Li Content and Equal-Channel Angular Pressing on Microstructure and Mechanical Properties of Al-Mg-Li Alloy

Joint effect of micro-sized Si particles and nano-sized dispersoids on the flow behavior and dynamic recrystallization of near-eutectic Al–Si based alloys during hot compression

Suchergebnisse filtern