UB Paderborn / Katalog / Suche / in CDI

1 – 25 von 1.754

Sortiert nach

Microstructural and mechanical characterization of injection molded 718 superalloy powders

Journal of alloys and compounds, 2013-11, Vol.576, p.140-153

2013

Link zum Volltext

Verfügbarkeit prüfen

Antimicrobial and antioxidant properties of the essential oils and methanol extract from Mentha longifolia L. ssp. longifolia

Food chemistry, 2007, Vol.103 (4), p.1449-1456

2007

Link zum Volltext

Verfügbarkeit prüfen

Evaporation and coverage area of pesticide droplets on hairy and waxy leaves

Biosystems engineering, 2009-11, Vol.104 (3), p.324-334

2009

Link zum Volltext

Verfügbarkeit prüfen

Allopolyploidy-Induced Rapid Genome Evolution in the Wheat (Aegilops-Triticum) Group

The Plant cell, 2001-08, Vol.13 (8), p.1735-1747

Ozkan, H.

2001

Link zum Volltext

Verfügbarkeit prüfen

Early ablation of Ccr2 in aggrecan-expressing cells following knee injury ameliorates joint damage and pain during post-traumatic osteoarthritis

Osteoarthritis and cartilage, 2022-12, Vol.30 (12), p.1616-1630

2022

Link zum Volltext

Verfügbarkeit prüfen

The effect of parity on obstetric and perinatal outcomes in pregnancies at the age of 40 and above: a retrospective study

Croatian Medical Journal, 2021-04, Vol.62 (2), p.130-136

2021

Link zum Volltext

Verfügbarkeit prüfen

Improvement in magnetic properties of La substituted BaFe12O19 particles prepared with an unusually low Fe/Ba molar ratio

Journal of magnetism and magnetic materials, 2011-07, Vol.323 (13), p.1799-1804

2011

Link zum Volltext

Verfügbarkeit prüfen

Modeling Acoustical Pressure and Particle Acceleration Close to Marine Seismic Airguns and Airgun Arrays

IEEE journal of oceanic engineering, 2019-07, Vol.44 (3), p.611-620

2019

Link zum Volltext
IEEE_Xplore

Powder injection molding of Stellite 6 powder: Sintering, microstructural and mechanical properties

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2016-01, Vol.651, p.914-924

2016

Link zum Volltext

Verfügbarkeit prüfen

Droplet evaporation and spread on waxy and hairy leaves associated with type and concentration of adjuvants

Pest management science, 2011-07, Vol.67 (7), p.842-851

2011

Link zum Volltext

Verfügbarkeit prüfen

Analysis of cerebral toxoplasmosis in a series of 170 allogeneic hematopoietic stem cell transplant patients

Transplant infectious disease, 2013-12, Vol.15 (6), p.575-580

2013

Link zum Volltext

Verfügbarkeit prüfen

Injection molding of nickel based 625 superalloy: Sintering, heat treatment, microstructure and mechanical properties

Journal of alloys and compounds, 2013-01, Vol.546, p.192-207

2013

Link zum Volltext

Verfügbarkeit prüfen

International Airgun Modeling Workshop: Validation of Source Signature and Sound Propagation Models-Dublin (Ireland), July 16, 2016-Problem Description

IEEE journal of oceanic engineering, 2019-07, Vol.44 (3), p.565-574

2019

Link zum Volltext
IEEE_Xplore

Role of the C-C chemokine receptor-2 in a murine model of injury-induced osteoarthritis

Osteoarthritis and cartilage, 2017-06, Vol.25 (6), p.914-925

2017

Link zum Volltext

Verfügbarkeit prüfen

Characterization of biomedical Ti-16Nb-(0–4)Sn alloys produced by Powder Injection Molding

Vacuum, 2017-08, Vol.142, p.164-174

2017

Link zum Volltext

Verfügbarkeit prüfen

Effect of Zr, Nb and Ti addition on injection molded 316L stainless steel for bio-applications: Mechanical, electrochemical and biocompatibility properties

Journal of the mechanical behavior of biomedical materials, 2015-11, Vol.51, p.215-224

2015

Link zum Volltext

Verfügbarkeit prüfen

Investigation of Li2O and TiO2 effects on MAS glass-ceramic produced from waste material

Science of sintering, 2023, Vol.55 (4), p.32-32

2023

Link zum Volltext

Verfügbarkeit prüfen

Independent Wheat B and G Genome Origins in Outcrossing Aegilops Progenitor Haplotypes

Molecular biology and evolution, 2007-01, Vol.24 (1), p.217-227

2007

Link zum Volltext

Verfügbarkeit prüfen

Effectiveness of prolotherapy in the treatment of chronic rotator cuff lesions

Orthopaedics & traumatology, surgery & research, 2017-05, Vol.103 (3), p.427-433

2017

Link zum Volltext

Verfügbarkeit prüfen

Benthic oxygen consumption rates during hypoxic conditions on the Oregon continental shelf: Evaluation of the eddy correlation method

Journal of Geophysical Research: Oceans, 2012-02, Vol.117 (C2), p.n/a

2012

Link zum Volltext

Verfügbarkeit prüfen

Temperature dependence of the isothermal bulk modulus of TiB2

Intermetallics, 2011-04, Vol.19 (4), p.596-598

Özkan, H.

2011

Link zum Volltext

Verfügbarkeit prüfen

Effects of mechanical activation on the non-isothermal kinetics of mullite formation from kaolinite

Journal of thermal analysis and calorimetry, 2011-03, Vol.103 (3), p.791-796

2011

Link zum Volltext

Verfügbarkeit prüfen

Temperature derivatives of the bulk modulus of ZrB2 calculated by using the pressure derivative of the bulk modulus

Philosophical magazine (Abingdon, England), 2014-01, Vol.94 (1), p.73-77

Özkan, H.

2014

Link zum Volltext

Verfügbarkeit prüfen

Experimentation and analysis of powder injection molded Ti10Nb10Zr alloy: a promising candidate for electrochemical and biomedical application

Journal of materials research and technology, 2019-11, Vol.8 (6), p.5233-5245

2019

Link zum Volltext

Verfügbarkeit prüfen

Evaporation rate and development of wetted area of water droplets with and without surfactant at different locations on waxy leaf surfaces

Biosystems engineering, 2010-05, Vol.106 (1), p.58-67

2010

Link zum Volltext

Verfügbarkeit prüfen

1 – 25 von 1.754

Suche als RSS-Feed

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(1.492)
Mit Volltextzugriff
(1.525)

Publikationsform

2 weitere anzeigen...

Weniger anzeigen...

Sprache

8 weitere anzeigen...

Weniger anzeigen...

Erscheinungsjahr

n.n

Thema

15 weitere anzeigen...

Weniger anzeigen...

Neu hinzugefügt

... seit 90 Tagen
(6)

Menü

Weitere Dienste

Einstellungen

Microstructural and mechanical characterization of injection molded 718 superalloy powders

Antimicrobial and antioxidant properties of the essential oils and methanol extract from Mentha longifolia L. ssp. longifolia

Evaporation and coverage area of pesticide droplets on hairy and waxy leaves

Allopolyploidy-Induced Rapid Genome Evolution in the Wheat (Aegilops-Triticum) Group

Early ablation of Ccr2 in aggrecan-expressing cells following knee injury ameliorates joint damage and pain during post-traumatic osteoarthritis

The effect of parity on obstetric and perinatal outcomes in pregnancies at the age of 40 and above: a retrospective study

Improvement in magnetic properties of La substituted BaFe12O19 particles prepared with an unusually low Fe/Ba molar ratio

Modeling Acoustical Pressure and Particle Acceleration Close to Marine Seismic Airguns and Airgun Arrays

Powder injection molding of Stellite 6 powder: Sintering, microstructural and mechanical properties

Droplet evaporation and spread on waxy and hairy leaves associated with type and concentration of adjuvants

Analysis of cerebral toxoplasmosis in a series of 170 allogeneic hematopoietic stem cell transplant patients

Injection molding of nickel based 625 superalloy: Sintering, heat treatment, microstructure and mechanical properties

International Airgun Modeling Workshop: Validation of Source Signature and Sound Propagation Models-Dublin (Ireland), July 16, 2016-Problem Description

Role of the C-C chemokine receptor-2 in a murine model of injury-induced osteoarthritis

Characterization of biomedical Ti-16Nb-(0–4)Sn alloys produced by Powder Injection Molding

Effect of Zr, Nb and Ti addition on injection molded 316L stainless steel for bio-applications: Mechanical, electrochemical and biocompatibility properties

Investigation of Li2O and TiO2 effects on MAS glass-ceramic produced from waste material

Independent Wheat B and G Genome Origins in Outcrossing Aegilops Progenitor Haplotypes

Effectiveness of prolotherapy in the treatment of chronic rotator cuff lesions

Benthic oxygen consumption rates during hypoxic conditions on the Oregon continental shelf: Evaluation of the eddy correlation method

Temperature dependence of the isothermal bulk modulus of TiB2

Effects of mechanical activation on the non-isothermal kinetics of mullite formation from kaolinite

Temperature derivatives of the bulk modulus of ZrB2 calculated by using the pressure derivative of the bulk modulus

Experimentation and analysis of powder injection molded Ti10Nb10Zr alloy: a promising candidate for electrochemical and biomedical application

Evaporation rate and development of wetted area of water droplets with and without surfactant at different locations on waxy leaf surfaces

Suchergebnisse filtern