UB Paderborn / Katalog / Suche / in CDI

Sortiert nach

On the role of Laves phases on the mechanical properties of Mg-Al-Ca alloys

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2019-05, Vol.756, p.272-283

2019

Link zum Volltext

Verfügbarkeit prüfen

Investigation of the deformation behavior of aluminum micropillars produced by focused ion beam machining using Ga and Xe ions

Scripta materialia, 2017-01, Vol.127, p.191-194

2017

Link zum Volltext

Verfügbarkeit prüfen

Softening non-metallic crystals by inhomogeneous elasticity

Scientific reports, 2017-09, Vol.7 (1), p.11602-9, Article 11602

2017

Link zum Volltext

Verfügbarkeit prüfen

Composition and cooling-rate dependence of plastic deformation, densification, and cracking in sodium borosilicate glasses during pyramidal indentation

Journal of non-crystalline solids, 2015-07, Vol.419, p.97-109

2015

Link zum Volltext

Verfügbarkeit prüfen

A rare-earth free magnesium alloy with improved intrinsic ductility

Scientific reports, 2017-09, Vol.7 (1), p.10458-10458, Article 10458

2017

Link zum Volltext

Verfügbarkeit prüfen

Synergistic effects of solutes on active deformation modes, grain boundary segregation and texture evolution in Mg-Gd-Zn alloys

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2022-07, Vol.847, p.143348, Article 143348

2022

Link zum Volltext

Verfügbarkeit prüfen

On the correlation of crystallographic macro-texture and magnetic magnetization anisotropy in non-oriented electrical steel

Journal of magnetism and magnetic materials, 2019-11, Vol.490, p.165485, Article 165485

2019

Link zum Volltext

Verfügbarkeit prüfen

Plasticity of the C15-CaAl2 Laves phase at room temperature

Materials & design, 2023-01, Vol.225, p.111504, Article 111504

2023

Link zum Volltext

Verfügbarkeit prüfen

Twinning effects in deformed and annealed magnesium–neodymium alloys

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2015-10, Vol.647, p.91-104

2015

Link zum Volltext

Verfügbarkeit prüfen

Investigation of the electroplastic effect using nanoindentation

Materials & design, 2019-12, Vol.183, p.108153, Article 108153

2019

Link zum Volltext

Verfügbarkeit prüfen

Preparation of Binary and Ternary Laves and µ-Phases in the Ta–Fe(–Al) System for Property Analysis at the Microscale

Metallurgical and materials transactions. A, Physical metallurgy and materials science, 2024-07, Vol.55 (7), p.2244-2263

2024

Link zum Volltext

Verfügbarkeit prüfen

Correlating magnetic properties of ferritic NO electrical steel containing 2.4 m.%Si with hot strip microstructure

Journal of magnetism and magnetic materials, 2020-05, Vol.501, p.166431, Article 166431

2020

Link zum Volltext

Verfügbarkeit prüfen

The influence of microstructural orientation on fracture toughness in (V, Al)N and (V, Al)(O, N) coatings as measured by microcantilever bending

Journal of materials research, 2023-08, Vol.38 (16), p.3950-3965

2023

Link zum Volltext

Verfügbarkeit prüfen

Strain heterogeneity and micro-damage nucleation under tensile stresses in an Mg–5Al–3Ca alloy with an intermetallic skeleton

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2019-11, Vol.767, p.138414, Article 138414

2019

Link zum Volltext

Verfügbarkeit prüfen

Co-deformation between the metallic matrix and intermetallic phases in a creep-resistant Mg-3.68Al-3.8Ca alloy

Materials & design, 2021-11, Vol.210, p.110113, Article 110113

2021

Link zum Volltext

Verfügbarkeit prüfen

Precipitation and decomposition phenomena in a Zn-Al-Cu-Mg alloy

Materials letters, 2016-07, Vol.175, p.27-31

2016

Link zum Volltext

Verfügbarkeit prüfen

Local mechanical properties of the (β0+ω0) composite in multiphase titanium aluminides studied with nanoindentation at room and high temperatures

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2016-05, Vol.665, p.135-140

2016

Link zum Volltext

Verfügbarkeit prüfen

Effect of the Interdependence of Cold Rolling Strategies and Subsequent Punching on Magnetic Properties of NO Steel Sheets

IEEE transactions on magnetics, 2016-05, Vol.52 (5), p.1-4

2016

Link zum Volltext
IEEE_Xplore

Anomalous yielding in the complex metallic alloy Al13Co4

Acta materialia, 2013-11, Vol.61 (19), p.7189-7196

2013

Link zum Volltext

Verfügbarkeit prüfen

On the structure of defects in the Fe7Mo6 μ-Phase

Acta materialia, 2019-04, Vol.167, p.257-266

2019

Link zum Volltext

Verfügbarkeit prüfen

The effect of large plastic deformation on elevated temperature mechanical behavior of dynamic strain aging Al-Mg alloys

Acta materialia, 2019-12, Vol.181, p.67-77

2019

Link zum Volltext

Verfügbarkeit prüfen

A new approach to measure fundamental microstructural influences on the magnetic properties of electrical steel using a miniaturized single sheet tester

Journal of magnetism and magnetic materials, 2023-10, Vol.583, p.171000, Article 171000

2023

Link zum Volltext

Verfügbarkeit prüfen

Microstructure-dependent magnetic properties of iron silicon single, bi- and oligo-crystals measured with a miniaturised Single-Sheet-Tester

Journal of magnetism and magnetic materials, 2023-11, Vol.585, p.171026, Article 171026

2023

Link zum Volltext

Verfügbarkeit prüfen

Plasticity of the Nb-rich μ-Co7Nb6 phase at room temperature and 600°C

Acta materialia, 2023-03, Vol.246, p.118720, Article 118720

2023

Link zum Volltext

Verfügbarkeit prüfen

Exploring solute behavior and texture selection in magnesium alloys at the atomistic level

Acta materialia, 2024-03, Vol.266, p.119677, Article 119677

2024

Link zum Volltext

Verfügbarkeit prüfen

1 – 25 von 121

Suche als RSS-Feed

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(115)
Mit Volltextzugriff
(121)

Publikationsform

Sprache

Englisch
(121)
Japanisch
(15)

Erscheinungsjahr

n.n

Thema

Science & Technology
(103)
Technology
(96)
Materials Science
(93)
Materials Science, Multidisciplinary
(90)
Metallurgy & Metallurgical Engineering
(47)
Science & Technology - Other Topics
(29)
Mechanical Properties
(27)
Nanoscience & Nanotechnology
(22)
Physics
(22)
Microstructure
(20)
Nanoindentation
(20)
Physical Sciences
(20)
Deformation
(14)
Plasticity
(13)
Texture
(13)
Deformation Mechanisms
(12)
Dislocations
(12)
Electron Microscopy
(11)
Grain Size
(11)
Physics, Applied
(11)

15 weitere anzeigen...

Weniger anzeigen...

Neu hinzugefügt

... seit 30 Tagen
(2)
... seit 90 Tagen
(4)

Menü

Weitere Dienste

Einstellungen

On the role of Laves phases on the mechanical properties of Mg-Al-Ca alloys

Investigation of the deformation behavior of aluminum micropillars produced by focused ion beam machining using Ga and Xe ions

Softening non-metallic crystals by inhomogeneous elasticity

Composition and cooling-rate dependence of plastic deformation, densification, and cracking in sodium borosilicate glasses during pyramidal indentation

A rare-earth free magnesium alloy with improved intrinsic ductility

Synergistic effects of solutes on active deformation modes, grain boundary segregation and texture evolution in Mg-Gd-Zn alloys

On the correlation of crystallographic macro-texture and magnetic magnetization anisotropy in non-oriented electrical steel

Plasticity of the C15-CaAl2 Laves phase at room temperature

Twinning effects in deformed and annealed magnesium–neodymium alloys

Investigation of the electroplastic effect using nanoindentation

Preparation of Binary and Ternary Laves and µ-Phases in the Ta–Fe(–Al) System for Property Analysis at the Microscale

Correlating magnetic properties of ferritic NO electrical steel containing 2.4 m.%Si with hot strip microstructure

The influence of microstructural orientation on fracture toughness in (V, Al)N and (V, Al)(O, N) coatings as measured by microcantilever bending

Strain heterogeneity and micro-damage nucleation under tensile stresses in an Mg–5Al–3Ca alloy with an intermetallic skeleton

Co-deformation between the metallic matrix and intermetallic phases in a creep-resistant Mg-3.68Al-3.8Ca alloy

Precipitation and decomposition phenomena in a Zn-Al-Cu-Mg alloy

Local mechanical properties of the (β0+ω0) composite in multiphase titanium aluminides studied with nanoindentation at room and high temperatures

Effect of the Interdependence of Cold Rolling Strategies and Subsequent Punching on Magnetic Properties of NO Steel Sheets

Anomalous yielding in the complex metallic alloy Al13Co4

On the structure of defects in the Fe7Mo6 μ-Phase

The effect of large plastic deformation on elevated temperature mechanical behavior of dynamic strain aging Al-Mg alloys

A new approach to measure fundamental microstructural influences on the magnetic properties of electrical steel using a miniaturized single sheet tester

Microstructure-dependent magnetic properties of iron silicon single, bi- and oligo-crystals measured with a miniaturised Single-Sheet-Tester

Plasticity of the Nb-rich μ-Co7Nb6 phase at room temperature and 600°C

Exploring solute behavior and texture selection in magnesium alloys at the atomistic level

Suchergebnisse filtern