UB Paderborn / Katalog / Suche / in CDI

Sortiert nach

Texture, misorientation and mechanical anisotropy in a deformed dual phase stainless steel weld joint

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2013-07, Vol.575, p.94-103

2013

Volltextzugriff (PDF)

Microstructure evolution and grain refinement in asymmetrically rolled aluminium

Acta materialia, 2014-09, Vol.76, p.404-412

2014

Volltextzugriff (PDF)

Texture, microstructure and anisotropic properties in annealed 2205 duplex stainless steel welds

Materials characterization, 2011-09, Vol.62 (9), p.833-843

2011

Volltextzugriff (PDF)

Modeling of latent hardening produced by complex loading paths in FCC alloys

International journal of plasticity, 2013-03, Vol.42, p.194-212

2013

Volltextzugriff (PDF)

Plastic strain-induced grain boundary migration (SIBM) in pure aluminum: SEM in-situ and AFM examinations

International journal of plasticity, 2019-04, Vol.115, p.29-55

2019

Volltextzugriff (PDF)

Microstructure evolution of titanium after tensile and recrystallisation

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2017-04, Vol.692, p.113-126

2017

Volltextzugriff (PDF)

Texture and microstructure variation in asymmetrically rolled steel

Materials characterization, 2016-08, Vol.118, p.235-243

2016

Volltextzugriff (PDF)

Micromechanical modelling of monotonic loading of CP α-Ti: Correlation between macroscopic and microscopic behaviour

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2013-06, Vol.573, p.222-233

2013

Volltextzugriff (PDF)

Evolution of recrystallization texture in non-oriented electrical steels during final annealing - influence of shear stress after cold rolling

Journal of physics. Conference series, 2019-08, Vol.1270 (1), p.12007

2019

Volltextzugriff (PDF)

Effect of solution treatment temperature on the precipitation kinetic of σ-phase in 2205 duplex stainless steel welds

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2008-11, Vol.496 (1), p.447-454

2008

Volltextzugriff (PDF)

Microstructure and mechanical behavior in dissimilar 13Cr/2205 stainless steel welded pipes

Materials & design, 2015-11, Vol.85, p.221-229

2015

Volltextzugriff (PDF)

Influence of a pre-deformation on the growth of titanium multicrystals

Journal of physics. Conference series, 2019-08, Vol.1270 (1), p.12045

2019

Volltextzugriff (PDF)

Investigation of plastic deformation heterogeneities in duplex steel by EBSD

Materials characterization, 2012-11, Vol.73 (Complete), p.52-60

2012

Volltextzugriff (PDF)

Microstructure evolution and mechanical behavior of a high strength dual-phase steel under monotonic loading

Materials characterization, 2015-02, Vol.100, p.152-162

2015

Volltextzugriff (PDF)

Microstructure evolution of titanium after tensile test

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2016-02, Vol.656, p.1-11

2016

Volltextzugriff (PDF)

The influence of microstructural features of individual grains on texture formation by strain-induced boundary migration in non-oriented electrical steels

Journal of materials science, 2014-02, Vol.49 (4), p.1764-1775

2014

Volltextzugriff (PDF)

A study of recovery and primary recrystallization mechanisms in a Zr–2Hf alloy

Acta materialia, 2005-11, Vol.53 (19), p.5131-5140

2005

Volltextzugriff (PDF)

A phenomenological anisotropic description for dislocation storage and recovery processes in fcc crystals

Computational materials science, 2012-03, Vol.54, p.97-100

2012

Volltextzugriff (PDF)

Analysis of textures heterogeneity in cold and warm asymmetrically rolled aluminium

Materials characterization, 2011-01, Vol.62 (1), p.22-34

2011

Volltextzugriff (PDF)

Texture and dislocation structures observation in a dual-phase steel under strain-path changes at large deformation

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2005-07, Vol.400, p.136-141

2005

Volltextzugriff (PDF)

The evolution with strain of the stored energy in different texture components of cold-rolled IF steel revealed by high resolution X-ray diffraction

Materials characterization, 2015-06, Vol.104, p.31-41

2015

Volltextzugriff (PDF)

Experimental and Finite Element Analysis of Asymmetric Rolling of 6061 Aluminum Alloy Using Two-Scale Elasto-Plastic Constitutive Relation

Archives of metallurgy and materials, 2017-12, Vol.62 (4), p.1991-1999

2017

Volltextzugriff (PDF)

The influence of grain morphology on texture measured after phase transformation in multiphase steels

Journal of materials science, 2014-08, Vol.49 (16), p.5646-5657

2014

Volltextzugriff (PDF)

Estimation of recrystallized volume fraction from EBSD data

Acta materialia, 2002-04, Vol.50 (6), p.1467-1477

2002

Volltextzugriff (PDF)

Microstructure heterogeneity after the ECAP process and its influence on recrystallization in aluminium

Materials characterization, 2013-04, Vol.78, p.60-68

2013

Volltextzugriff (PDF)

1 – 25 von 390

Suche als RSS-Feed

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(369)
Mit Volltextzugriff
(380)

Publikationsform

Sprache

Erscheinungsjahr

n.n

Thema

Science & Technology
(342)
Technology
(341)
Materials Science
(331)
Materials Science, Multidisciplinary
(319)
Metallurgy & Metallurgical Engineering
(281)
Crystallography
(226)
Physical Sciences
(217)
Recrystallization
(80)
Texture
(78)
Exact Sciences And Technology
(64)
Physics
(59)
Applied Sciences
(51)
Metals. Metallurgy
(47)
Microstructure
(41)
Grain Growth
(38)
Cross-Disciplinary Physics: Materials Science; Rheology
(34)
Ebsd
(33)
Mechanics Of Materials
(31)
Mechanics
(28)
Treatment Of Materials And Its Effects On Microstructure And Properties
(28)

15 weitere anzeigen...

Weniger anzeigen...

Menü

Weitere Dienste

Einstellungen

Texture, misorientation and mechanical anisotropy in a deformed dual phase stainless steel weld joint

Microstructure evolution and grain refinement in asymmetrically rolled aluminium

Texture, microstructure and anisotropic properties in annealed 2205 duplex stainless steel welds

Modeling of latent hardening produced by complex loading paths in FCC alloys

Plastic strain-induced grain boundary migration (SIBM) in pure aluminum: SEM in-situ and AFM examinations

Microstructure evolution of titanium after tensile and recrystallisation

Texture and microstructure variation in asymmetrically rolled steel

Micromechanical modelling of monotonic loading of CP α-Ti: Correlation between macroscopic and microscopic behaviour

Evolution of recrystallization texture in non-oriented electrical steels during final annealing - influence of shear stress after cold rolling

Effect of solution treatment temperature on the precipitation kinetic of σ-phase in 2205 duplex stainless steel welds

Microstructure and mechanical behavior in dissimilar 13Cr/2205 stainless steel welded pipes

Influence of a pre-deformation on the growth of titanium multicrystals

Investigation of plastic deformation heterogeneities in duplex steel by EBSD

Microstructure evolution and mechanical behavior of a high strength dual-phase steel under monotonic loading

Microstructure evolution of titanium after tensile test

The influence of microstructural features of individual grains on texture formation by strain-induced boundary migration in non-oriented electrical steels

A study of recovery and primary recrystallization mechanisms in a Zr–2Hf alloy

A phenomenological anisotropic description for dislocation storage and recovery processes in fcc crystals

Analysis of textures heterogeneity in cold and warm asymmetrically rolled aluminium

Texture and dislocation structures observation in a dual-phase steel under strain-path changes at large deformation

The evolution with strain of the stored energy in different texture components of cold-rolled IF steel revealed by high resolution X-ray diffraction

Experimental and Finite Element Analysis of Asymmetric Rolling of 6061 Aluminum Alloy Using Two-Scale Elasto-Plastic Constitutive Relation

The influence of grain morphology on texture measured after phase transformation in multiphase steels

Estimation of recrystallized volume fraction from EBSD data

Microstructure heterogeneity after the ECAP process and its influence on recrystallization in aluminium

Suchergebnisse filtern