UB Paderborn / Katalog / Suche / in CDI

Numerical studies of simultaneously developing laminar flow and heat transfer in microtubes with thick wall and constant outside wall temperature

International journal of heat and mass transfer, 2010-09, Vol.53 (19), p.3977-3989

2010

Link zum Volltext

Verfügbarkeit prüfen

Preparation, microstructure and microwave dielectric properties of ZrxTi1-xO4 (x = 0.40-0.60) ceramics

Journal of the European Ceramic Society, 2001-12, Vol.21 (16), p.2931-2936

2001

Link zum Volltext

Verfügbarkeit prüfen

Modeling of imperfect mixing and its effects on polymer properties

AIChE journal, 1997-05, Vol.43 (5), p.1265-1277

1997

Link zum Volltext

Verfügbarkeit prüfen

Runaway phenomena in low-density polyethylene autoclave reactors

AIChE journal, 1996-10, Vol.42 (10), p.2911-2925

1996

Link zum Volltext

Verfügbarkeit prüfen

General relation between tensile strength and fatigue strength of metallic materials

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2013-03, Vol.564, p.331-341

2013

Link zum Volltext

Verfügbarkeit prüfen

Size-dependent shear fracture and global tensile plasticity of metallic glasses

Acta materialia, 2009, Vol.57 (1), p.257-266

2009

Link zum Volltext

Verfügbarkeit prüfen

Crack initiation mechanism of extruded AZ31 magnesium alloy in the very high cycle fatigue regime

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2008-09, Vol.491 (1), p.131-136

2008

Link zum Volltext

Verfügbarkeit prüfen

Annealing induced recovery of long-term thermal aging embrittlement in a duplex stainless steel

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2013-03, Vol.564, p.85-91

2013

Link zum Volltext

Verfügbarkeit prüfen

Enhanced very high cycle fatigue performance of extruded Mg–12Gd–3Y–0.5Zr magnesium alloy

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2011-03, Vol.528 (6), p.2231-2238

2011

Link zum Volltext

Verfügbarkeit prüfen

Long-term trends in visibility and impacts of aerosol composition on visibility impairment in Baoji, China

Atmospheric research, 2014-11, Vol.149, p.88-95

2014

Link zum Volltext

Verfügbarkeit prüfen

Structure and mechanical properties of Ti–6Al–4V alloy after zirconium addition

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2012-08, Vol.552, p.295-300

2012

Link zum Volltext

Verfügbarkeit prüfen

Strain localization and fatigue cracking behaviors of Cu bicrystal with an inclined twin boundary

Acta materialia, 2014-07, Vol.73, p.167-176

2014

Link zum Volltext

Verfügbarkeit prüfen

Microstructure evolution and impact fracture behaviors of Z3CN20-09M stainless steels after long-term thermal aging

Journal of nuclear materials, 2013-02, Vol.433 (1-3), p.41-49

2013

Link zum Volltext

Verfügbarkeit prüfen

The fatigue behaviors of zero-inclusion and commercial 42CrMo steels in the super-long fatigue life regime

Acta materialia, 2004-10, Vol.52 (18), p.5235-5241

2004

Link zum Volltext

Verfügbarkeit prüfen

Varying tensile fracture mechanisms of Cu and Cu–Zn alloys with reduced grain size: From necking to shearing instability

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2014-01, Vol.594, p.309-320

2014

Link zum Volltext

Verfügbarkeit prüfen

Tensile behavior at 700°C in Ti–Al–Sn–Zr–Mo–Nb–W–Si alloy with a bi-modal microstructure

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2014-02, Vol.595, p.159-164

2014

Link zum Volltext

Verfügbarkeit prüfen

Enhancing strength and ductility of Mg–12Gd–3Y–0.5Zr alloy by forming a bi-ultrafine microstructure

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2011-05, Vol.528 (13), p.4300-4311

2011

Link zum Volltext

Verfügbarkeit prüfen

Surface functionalization of nanostructured silver-coated polyester fabric by magnetron sputtering

Surface & coatings technology, 2010-08, Vol.204 (21), p.3662-3667

2010

Link zum Volltext

Verfügbarkeit prüfen

On the critical inclusion size of high strength steels under ultra-high cycle fatigue

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2006-07, Vol.427 (1), p.167-174

2006

Link zum Volltext

Verfügbarkeit prüfen

Plastic deformability of metallic glass by artificial macroscopic notches

Acta materialia, 2010-09, Vol.58 (16), p.5420-5432

2010

Link zum Volltext

Verfügbarkeit prüfen

Fatigue properties of rolled magnesium alloy (AZ31) sheet: Influence of specimen orientation

International journal of fatigue, 2011-05, Vol.33 (5), p.672-682

2011

Link zum Volltext

Verfügbarkeit prüfen

Strengthening mechanism of two-phase titanium alloys with basketweave microstructure

Journal of alloys and compounds, 2014-08, Vol.603, p.42-47

2014

Link zum Volltext

Verfügbarkeit prüfen

Influences of crystallographic orientations on deformation mechanism and grain refinement of Al single crystals subjected to one-pass equal-channel angular pressing

Acta materialia, 2007-10, Vol.55 (17), p.5889-5900

2007

Link zum Volltext

Verfügbarkeit prüfen

A multi-component Zr alloy with comparable strength and Higher plasticity than Zr-based bulk metallic glasses

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2013-01, Vol.561, p.13-16

2013

Link zum Volltext

Verfügbarkeit prüfen

The anisotropy and diverse mechanical properties of rolled Mg–3% Al–1% Zn alloy

Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2014-11, Vol.618, p.523-532

2014

Link zum Volltext

Verfügbarkeit prüfen

Menü

Weitere Dienste

Einstellungen

Numerical studies of simultaneously developing laminar flow and heat transfer in microtubes with thick wall and constant outside wall temperature

Preparation, microstructure and microwave dielectric properties of ZrxTi1-xO4 (x = 0.40-0.60) ceramics

Modeling of imperfect mixing and its effects on polymer properties

Runaway phenomena in low-density polyethylene autoclave reactors

General relation between tensile strength and fatigue strength of metallic materials

Size-dependent shear fracture and global tensile plasticity of metallic glasses

Crack initiation mechanism of extruded AZ31 magnesium alloy in the very high cycle fatigue regime

Annealing induced recovery of long-term thermal aging embrittlement in a duplex stainless steel

Enhanced very high cycle fatigue performance of extruded Mg–12Gd–3Y–0.5Zr magnesium alloy

Long-term trends in visibility and impacts of aerosol composition on visibility impairment in Baoji, China

Structure and mechanical properties of Ti–6Al–4V alloy after zirconium addition

Strain localization and fatigue cracking behaviors of Cu bicrystal with an inclined twin boundary

Microstructure evolution and impact fracture behaviors of Z3CN20-09M stainless steels after long-term thermal aging

The fatigue behaviors of zero-inclusion and commercial 42CrMo steels in the super-long fatigue life regime

Varying tensile fracture mechanisms of Cu and Cu–Zn alloys with reduced grain size: From necking to shearing instability

Tensile behavior at 700°C in Ti–Al–Sn–Zr–Mo–Nb–W–Si alloy with a bi-modal microstructure

Enhancing strength and ductility of Mg–12Gd–3Y–0.5Zr alloy by forming a bi-ultrafine microstructure

Surface functionalization of nanostructured silver-coated polyester fabric by magnetron sputtering

On the critical inclusion size of high strength steels under ultra-high cycle fatigue

Plastic deformability of metallic glass by artificial macroscopic notches

Fatigue properties of rolled magnesium alloy (AZ31) sheet: Influence of specimen orientation

Strengthening mechanism of two-phase titanium alloys with basketweave microstructure

Influences of crystallographic orientations on deformation mechanism and grain refinement of Al single crystals subjected to one-pass equal-channel angular pressing

A multi-component Zr alloy with comparable strength and Higher plasticity than Zr-based bulk metallic glasses

The anisotropy and diverse mechanical properties of rolled Mg–3% Al–1% Zn alloy

Aktive Filter

Suchergebnisse filtern