UB Paderborn / Katalog / Suche / in CDI

Sortiert nach

Einfacher Volltextzugriff von (fast) überall

Installieren Sie die LibKey Nomad-Browsererweiterung und erhalten Sie von vielen Webseiten einfachen Zugriff auf lizenzierte Volltexte oder Open Access Publikationen. Mehr erfahren...

Corrosion mechanisms in titanium oxide-based films produced by anodic treatment

Electrochimica acta, 2017-04, Vol.234, p.16-27

2017

Volltextzugriff (PDF)

Degradation behavior of Ti-Nb alloys: Corrosion behavior through 21 days of immersion and tribocorrosion behavior against alumina

Corrosion science, 2020-05, Vol.167, p.108488, Article 108488

2020

Volltextzugriff (PDF)

Theoretical and numerical analysis on phase change materials (PCM): A case study of the solidification process of erythritol in spheres

International journal of heat and mass transfer, 2018-04, Vol.119, p.523-532

2018

Volltextzugriff (PDF)

Growth mechanisms of Ca- and P-rich MAO films in Ti-15Zr-xMo alloys for osseointegrative implants

Surface & coatings technology, 2018-06, Vol.344, p.373-382

2018

Volltextzugriff (PDF)

Enhanced printability of thermoplastic polyurethane substrates by silica particles surface interactions

Applied surface science, 2016-01, Vol.360, p.198-206

2016

Volltextzugriff (PDF)

Do oral biofilms influence the wear and corrosion behavior of titanium?

Biofouling (Chur, Switzerland), 2010-05, Vol.26 (4), p.471-478

2010

Volltextzugriff (PDF)

Synergism between corrosion and wear on CoCrMo−Al2O3 biocomposites in a physiological solution

Tribology international, 2015-11, Vol.91, p.198-205

2015

Volltextzugriff (PDF)

TiCxOy thin films for decorative applications : Tribocorrosion mechanisms and synergism

Tribology international, 2008-07, Vol.41 (7), p.603-615

2008

Volltextzugriff (PDF)

Epidemiology and outcome of HIV-infected patients admitted to the ICU in the current highly active antiretroviral therapy era

Medicina intensiva, 2020-06, Vol.44 (5), p.283-293

2020

Volltextzugriff (PDF)

Hope and doubt for the world's marine ecosystems

Perspectives in ecology and conservation, 2019-01, Vol.17 (1), p.19-25

2019

Volltextzugriff (PDF)

On the mechanical biocompatibility of Ti-15Zr-based alloys for potential use as load-bearing implants

Journal of materials research and technology, 2020-03, Vol.9 (2), p.1241-1250

2020

Volltextzugriff (PDF)

Mob rulers and part-time cleaners: two reef fish associations at the isolated Ascension Island

Journal of the Marine Biological Association of the United Kingdom, 2017-06, Vol.97 (4), p.799-811

2017

Volltextzugriff (PDF)

Screening of gellan gum as an ionic and hydrophobic chromatographic matrix for biomolecules purification

Separation and purification technology, 2014-08, Vol.132, p.452-460

2014

Volltextzugriff (PDF)

Using dynamic voltage drive in a parallel-plate electrostatic actuator for full-gap travel range and positioning

Journal of microelectromechanical systems, 2006-02, Vol.15 (1), p.69-83

2006

Volltextzugriff (PDF)

Microstructure and mechanical properties of nanocomposite (Ti,Si,Al)N coatings

Thin solid films, 2001-11, Vol.398, p.391-396

2001

Volltextzugriff (PDF)

Determination of the Maximal Lactate Steady State in Obese Zucker Rats

International journal of sports medicine, 2013-03, Vol.34 (3), p.214-217

2013

Volltextzugriff (PDF)

Tribological properties of the directionally oriented warp knit GFRP composites

Wear, 2007-09, Vol.263 (7), p.930-938

2007

Volltextzugriff (PDF)

A comparative study on the dry sliding wear behaviour of nitrocarburised, gas nitrided, fluidised-bed nitrided, and plasma nitrided plastic mould steel

International journal of surface science and engineering, 2016, Vol.10 (5), p.468

2016

Volltextzugriff (PDF)

Incidence of Fetal Heart Diseases in High-Risk Pregnancies: Initial Experience With a Screening Protocol in a Tertiary Referral Center in Brazil

Ultrasound in medicine & biology, 2013-05, Vol.39 (5), p.S45-S45

2013

Volltextzugriff (PDF)

Analysis and analytical modeling of static pull-In with application to MEMS-based voltage reference and process monitoring

Journal of microelectromechanical systems, 2004-04, Vol.13 (2), p.342-354

2004

Volltextzugriff (PDF)

Micro-arc oxidation as a tool to develop multifunctional calcium-rich surfaces for dental implant applications

Materials Science & Engineering C, 2015-09, Vol.54, p.196-206

2015

Volltextzugriff (PDF)

Preparation and characterization of new Ni-aluminosilicate catalysts and their performance in the epoxidation of ( Z)-cyclooctene

Applied catalysis. A, General, 2007-03, Vol.319 (1), p.153-162

2007

Volltextzugriff (PDF)

Corrosion and tribocorrosion behaviour of Al–Si–Cu–Mg alloy and its composites reinforced with B4C particles in 0.05M NaCl solution

Wear, 2013-08, Vol.306 (1-2), p.27-35

2013

Volltextzugriff (PDF)

SVET, SKP and EIS study of the corrosion behaviour of high strength Al and Al–Li alloys used in aircraft fabrication

Corrosion science, 2014-07, Vol.84, p.30-41

2014

Volltextzugriff (PDF)

A comparative investigation of the corrosion and tribocorrosion behaviour of nitrocarburized, gas nitrided, fluidized-bed nitrided, and plasma nitrided plastic mould steel

Surface & coatings technology, 2018-01, Vol.334, p.116-123

2018

Volltextzugriff (PDF)

1 – 25 von 449

Suche als RSS-Feed

Aktive Filter

SpracheEnglisch

Suchergebnisse filtern

Filter anzeigen

Nur zeigen

Geprüft (Peer-Review)
(377)
Mit Volltextzugriff
(415)

Publikationsform

Sprache

Erscheinungsjahr

n.n

Thema

Science & Technology
(316)
Technology
(171)
Life Sciences & Biomedicine
(132)
Engineering
(99)
Physical Sciences
(82)
Materials Science
(67)
Humans
(57)
Materials Science, Multidisciplinary
(42)
Engineering, Electrical & Electronic
(40)
Physics
(40)
Female
(37)
Exact Sciences And Technology
(35)
Animals
(34)
Male
(34)
Engineering, Mechanical
(33)
Instruments & Instrumentation
(27)
Physics, Applied
(27)
Biological And Medical Sciences
(26)
Corrosion
(24)
Adult
(23)

15 weitere anzeigen...

Weniger anzeigen...

Neu hinzugefügt

... seit 90 Tagen
(2)

Menü

Weitere Dienste

Einstellungen

Corrosion mechanisms in titanium oxide-based films produced by anodic treatment

Degradation behavior of Ti-Nb alloys: Corrosion behavior through 21 days of immersion and tribocorrosion behavior against alumina

Theoretical and numerical analysis on phase change materials (PCM): A case study of the solidification process of erythritol in spheres

Growth mechanisms of Ca- and P-rich MAO films in Ti-15Zr-xMo alloys for osseointegrative implants

Enhanced printability of thermoplastic polyurethane substrates by silica particles surface interactions

Do oral biofilms influence the wear and corrosion behavior of titanium?

Synergism between corrosion and wear on CoCrMo−Al2O3 biocomposites in a physiological solution

TiCxOy thin films for decorative applications : Tribocorrosion mechanisms and synergism

Epidemiology and outcome of HIV-infected patients admitted to the ICU in the current highly active antiretroviral therapy era

Hope and doubt for the world's marine ecosystems

On the mechanical biocompatibility of Ti-15Zr-based alloys for potential use as load-bearing implants

Mob rulers and part-time cleaners: two reef fish associations at the isolated Ascension Island

Screening of gellan gum as an ionic and hydrophobic chromatographic matrix for biomolecules purification

Using dynamic voltage drive in a parallel-plate electrostatic actuator for full-gap travel range and positioning

Microstructure and mechanical properties of nanocomposite (Ti,Si,Al)N coatings

Determination of the Maximal Lactate Steady State in Obese Zucker Rats

Tribological properties of the directionally oriented warp knit GFRP composites

A comparative study on the dry sliding wear behaviour of nitrocarburised, gas nitrided, fluidised-bed nitrided, and plasma nitrided plastic mould steel

Incidence of Fetal Heart Diseases in High-Risk Pregnancies: Initial Experience With a Screening Protocol in a Tertiary Referral Center in Brazil

Analysis and analytical modeling of static pull-In with application to MEMS-based voltage reference and process monitoring

Micro-arc oxidation as a tool to develop multifunctional calcium-rich surfaces for dental implant applications

Preparation and characterization of new Ni-aluminosilicate catalysts and their performance in the epoxidation of ( Z)-cyclooctene

Corrosion and tribocorrosion behaviour of Al–Si–Cu–Mg alloy and its composites reinforced with B4C particles in 0.05M NaCl solution

SVET, SKP and EIS study of the corrosion behaviour of high strength Al and Al–Li alloys used in aircraft fabrication

A comparative investigation of the corrosion and tribocorrosion behaviour of nitrocarburized, gas nitrided, fluidized-bed nitrided, and plasma nitrided plastic mould steel

Aktive Filter

Suchergebnisse filtern