Details

Autor(en) / Beteiligte

• Mitrinova, Z.
• Tcholakova, S.
• Golemanov, K.
• Denkov, N.
• Vethamuthu, M.
• Ananthapadmanabhan, K.P.

Titel

Surface and foam properties of SLES+CAPB+fatty acid mixtures: Effect of pH for C12–C16 acids

Ist Teil von

• Colloids and surfaces. A, Physicochemical and engineering aspects, 2013-12, Vol.438, p.186-198

Ort / Verlag

Elsevier B.V

Erscheinungsjahr

2013

Quelle

Alma/SFX Local Collection

Beschreibungen/Notizen

• [Display omitted] ► Effects of pH and fatty acid chain length on foam and surface properties is studied. ► Increase of pH above a threshold value leads to sharp decrease of surface modulus. ► Decrease of surface modulus below 100mN/m leads to jump in foam properties. ► Threshold pH value increases from 8 to 11 with the increase of acid chain length Recently we showed that triple surfactant mixtures, comprising the anionic surfactant SLES, zwitterionic surfactant CAPB and long-chain fatty acid (FAc), possess very high surface modulus which can be used to modify the dynamic properties of foams (Golemanov et al. Langmuir 2008, 24, 9956). In the current paper we perform a systematic experimental study of the effects of several factors on the surface tension, surface dilatational modulus, viscous friction inside sheared foam, foam-wall friction, and mean bubble size in sheared foams, for such triple surfactant mixtures. The factors studied are: (1) chain length of fatty acid; (2) fatty acid concentration; (3) pH; (4) presence of glycerol in the aqueous solution. Lauric (C12Ac), myristic (C14Ac) and palmitic (C16Ac) acids are studied. The concentrations of the main surfactants were fixed, 10mM for SLES and 5mM for CAPB. Varying the myristic acid (C14Ac) concentration, CC14Ac, we observed two ranges: (1) At CC14Ac<0.06mM, the acid increases the solution surface modulus up to 50mN/m, however, without affecting significantly any of the other properties studied; (2) At CC14Ac>0.11mM, C14Ac leads to significant decrease of surface tension (from 29 to 22mN/m), increase of surface modulus (from 50 to 400mN/m), decrease of mean bubble size in sheared foams (from 300 to 150μm), and strong increase of the inside-foam friction and foam-wall friction. Qualitatively similar results are obtained with the other FAc studied. Mass-balance estimates show that low surface tension and high surface modulus are observed, when the molar fraction of FAc in the adsorption layer approaches ca. 30%. The main role of FAc is to induce a surface phase transition, leading to formation of surface condensed phase in the mixed adsorption layer. For all systems studied, the increase of pH above a certain transitional value leads to a sharp increase of surface tension and decrease of surface dilatational modulus, which is accompanied with a decrease in the inside-foam and foam-wall viscous friction. The transitional pH value varies between 8 and 11, and increases with the fatty acid chain-length. The increase of pH causes ionization of the FAc molecules – the latter start to behave as usual anionic surfactant without forming surface condensed phase. The main effect of glycerol is to decrease the transitional pH (by 1 to 1.5 units for 40wt% glycerol), without affecting significantly the system properties away from the transitional pH. These results clarify the compositional domain, in which the fatty acids can be used for control of surface and foam properties in such surfactant mixtures.