International journal of advanced manufacturing technology, 2023-08, Vol.127 (9-10), p.4439-4452
2023
Volltextzugriff (PDF)
Details
- Autor(en) / Beteiligte
- Titel
- Modeling of tow-to-spot diameter ratio for laser cutting of single-layer carbon fiber–reinforced plastics (CFRP)
- Ist Teil von
- International journal of advanced manufacturing technology, 2023-08, Vol.127 (9-10), p.4439-4452
- Ort / Verlag
- London: Springer London
- Erscheinungsjahr
- 2023
- Quelle
- Alma/SFX Local Collection
- Beschreibungen/Notizen
- Carbon fiber–reinforced plastics (CFRP) is a kind of advanced composite material with resin as the matrix and carbon fiber as the reinforcing phase. Due to differences in material orientation, laser cutting of CFRP exhibits anisotropic characteristics. In order to study the influence of material anisotropy on energy conduction in laser cutting CFRP, taking single-layer CFRP as the research object, based on the heat conduction theory and the mixing rate of composite materials, the three-dimensional finite element models of single fiber arrangement with tow-to-spot (fiber tow to laser spot) diameter ratio of 1:1, 1:2, 1:5, and 1:10 are established by using the commercial software ANSYS. Through the numerical simulation of the same-direction laser cutting process, the material temperature field and cross-section temperature gradient are analyzed. The results show that with the increase of fiber arrangement density (tow-to-spot diameter ratio approaching 1:10), the width of the heat-affected zone decreases, but the maximum temperature increases, which means that the temperature gradient increases. Therefore, it is speculated that when a larger laser spot is used (tow-to-spot diameter ratio is much smaller than 1:10), CFRP can be treated as a homogeneous composite. In order to verify the effectiveness of the model, a slit aperture is used to control the tow-to-spot diameter ratio at about 1:7, and a CO 2 continuous laser is used for cutting experiments. By fitting the experimental measurements with the width of the carbon fiber ablation area and heat-affected zone in the numerical simulation results, it is found that there is a logarithmic correlation between both the width and the tow-to-spot diameter ratio. There are 3.37% and 1.92% deviations between the experimental result and the theoretical value, respectively. The agreement is relatively good, which can prove the effectiveness of the model. In conclusion, the establishment of a tow-to-spot diameter ratio model reveals the response characteristics of anisotropic materials to energy input and conduction in the process of laser cutting, especially the difference of radial and axial conduction efficiency. The influence mechanism of fiber arrangement mode (mainly density in this work) on temperature field and cutting effect is clarified, which provides important theoretical support and experimental basis for the laser precision cutting method of CFRP materials. Graphical abstract
- Sprache
- Englisch
- Identifikatoren
- ISSN: 0268-3768eISSN: 1433-3015DOI: 10.1007/s00170-023-11749-8Titel-ID: cdi_proquest_journals_2840071004
- Format
- –
- Schlagworte
- Ablation, Anisotropy, CAD, CAE) and Design, Carbon fiber reinforced plastics, Carbon fibers, Composite materials, Computer aided design, Computer simulation, Computer-Aided Engineering (CAD, Conduction heating, Conductive heat transfer, Density, Diameters, Effectiveness, Engineering, Fiber lasers, Finite element method, Heat affected zone, Industrial and Production Engineering, Laser beam cutting, Lasers, Mathematical models, Mechanical Engineering, Media Management, Original Article, Temperature distribution, Three dimensional composites, Three dimensional models, Tow (textiles)