Details

Autor(en) / Beteiligte

• Zhang, Ming-ya
• Zhang, Yu-qin
• Yu, Hui
• Wang, Hong-xia
• Niu, Xiao-feng
• Wang, Li-fei
• Li, Hang
• Cheng, Wei-li

Titel

Revealing the deformation behavior and resultant texture evolution in extruded dilute Mg–Bi–Sn–Ca alloy during hot compression

Ist Teil von

• Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2022-09, Vol.853, p.143788, Article 143788

Ort / Verlag

Lausanne: Elsevier B.V

Erscheinungsjahr

2022

Quelle

Elsevier ScienceDirect Journals

Beschreibungen/Notizen

• In this paper, the deformation behavior and resultant texture evolution of an extruded dilute Mg-0.5Bi-0.5Sn-0.5Ca (BTX000) alloy during hot compression with different strain rates were studied. The results indicated that the activation of twins and dynamic recrystallization (DRX) are greatly dependent on the strain rates. The critical shear stress (CRSS) of twinning ranged from 66 to 197 MPa at different strain rates. In the case of strain rate of 3.3 s −1, the largest CRSS value led to the lowest area fraction of twins and the strongest texture intensity. In addition, the DRX extent increased with the increased strain rate. This phenomenon was caused by the variation in local stress concentration due to the different degrees of dislocation accumulation generated at different strain rates. More specifically, the dominant DRX mechanism at low strain rates was CDRX, while at high strain rates, the dominant DRX mechanisms were CDRX and twin-induced dynamic recrystallization (TDRX). Furthermore, the activation of twinning and DRX process altered the crystal orientation from favorable for basal slip to non-basal slip. This shows that, in addition to twinning, non-basal dislocation slip could be activated, and it plays an important role in plastic deformation behavior of extruded BTX000 alloy. The experimental results of this study provide new insight for further improving the plastic deformation ability of dilute Mg alloy. •The CRSS required for twinning greatly depended on the strain rates in this study.•The driving force required for DRX process decreases with increasing strain rate.•Both CDRX and TDRX mechanisms supplying more DRX kinetics at high strain rate.•Non-basal slip is easily activated and plays an important role during compression.