Details

Autor(en) / Beteiligte

• Tirunilai, A.S.
• Hanemann, T.
• Reinhart, C.
• Tschan, V.
• Weiss, K.-P.
• Laplanche, G.
• Freudenberger, J.
• Heilmaier, M.
• Kauffmann, A.

Titel

Comparison of cryogenic deformation of the concentrated solid solutions CoCrFeMnNi, CoCrNi and CoNi

Ist Teil von

• Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2020-05, Vol.783, p.139290, Article 139290

Ort / Verlag

Lausanne: Elsevier B.V

Erscheinungsjahr

2020

Quelle

Access via ScienceDirect (Elsevier)

Beschreibungen/Notizen

• The current work compares the deformation behavior of CoCrFeMnNi and CoCrNi in the temperature interval between 295 K and 8 K through a series of quasi-static tensile tests. Temperature-dependent yield stress variation was found to be similarly high in these two alloys. Previous investigations only extended down to 77 K and showed that a small amount of ε-martensite was formed in CoCrNi while this phase was not observed in CoCrFeMnNi. The present study extends these investigations down to 8 K where similar low levels of ε-martensite were presently detected. Based on this result, a rough assessment has been made estimating the importance of deformation twinning to the strength. The relative work hardening rates of CoCrFeMnNi and CoCrNi were comparable in value despite the differences in ε-martensite formation during deformation. CoCrFeMnNi deforms by dislocation slip and deformation twinning while deformation in CoCrNi is also accommodated by the formation of ε-martensite at cryogenic temperatures. Additionally, CoNi, a solid solution from the Co–Cr–Fe–Mn–Ni system with low strength, was used for comparison, showing contrasting deformation behavior at cryogenic temperatures.