Details

Autor(en) / Beteiligte

• Zhou, Yue
• Chen, Suiyuan
• Chen, Xueting
• Cui, Tong
• Liang, Jing
• Liu, Changsheng

Titel

The evolution of bainite and mechanical properties of direct laser deposition 12CrNi2 alloy steel at different laser power

Ist Teil von

• Materials science & engineering. A, Structural materials : properties, microstructure and processing, 2019-01, Vol.742, p.150-161

Ort / Verlag

Lausanne: Elsevier B.V

Erscheinungsjahr

2019

Quelle

Alma/SFX Local Collection

Beschreibungen/Notizen

• In this paper, 12CrNi2 alloy steel samples were successfully fabricated by direct laser deposition (DLD) technology. The evolution of bainite in the DLD 12CrNi2 alloy steel process at different laser power of 1800 W, 2000 W and 2200 W and mechanical properties of as-deposited samples were investigated. The results showed that the middle-upper microstructure of the samples fabricated at different laser power transformed from lath bainite (LB) to granular bainite (GB) with increasing laser power. In addition, granular bainite was divided into blocky granular bainite (GB1) and lath-like granular bainite (GB2) according to different formation mechanisms, and the amount of GB1 increased and GB2 decreased in the range of laser power from 2000 W to 2200 W. No preferred texture was observed in the EBSD maps due to the complex heat flux direction which was resulted in the reciprocating scanning strategy. With the increase of laser power, the proportion of high-angle grain boundaries increased from 33.1% to 46.4% and that of low-angle grain boundaries decreased from 66.9% to 53.6%. The sample fabricated at 2000 W had the highest mean microhardness (331 HV0.2) and the best combination of ultimate tensile strength (757 MPa) and elongation (9.1%). However, the sample fabricated at 2200 W had the best impact toughness (aku = 100.0 J/cm2) because it contained a large amount of GB1 with dispersive and spherical-like island structures. This study provides the theoretical and experimental basis for the design of laser power and controllability of microstructure and properties in the DLD alloy steel process.