Sie befinden Sich nicht im Netzwerk der Universität Paderborn. Der Zugriff auf elektronische Ressourcen ist gegebenenfalls nur via VPN oder Shibboleth (DFN-AAI) möglich. mehr Informationen...
Ergebnis 22 von 2008

Details

Autor(en) / Beteiligte
Titel
Trapping and Reliability Assessment in D-Mode GaN-Based MIS-HEMTs for Power Applications
Ist Teil von
  • IEEE transactions on power electronics, 2014-05, Vol.29 (5), p.2199-2207
Ort / Verlag
New York: IEEE
Erscheinungsjahr
2014
Quelle
IEEE/IET Electronic Library (IEL)
Beschreibungen/Notizen
  • This paper reports on an extensive analysis of the trapping processes and of the reliability of experimental AlGaN/GaN MIS-HEMTs, grown on silicon substrate. The study is based on combined pulsed characterization, transient investigation, breakdown, and reverse-bias stress tests, and provides the following, relevant, information: 1) the exposure to high gate-drain reverse-bias may result in a recoverable increase in the on-resistance (RON), and in a slight shift in threshold voltage; 2) devices with a longer gate-drain distance show a stronger increase in RON, compared to smaller devices; 3)current transient measurements indicate the existence of one trap level, with activation energy of 1.03 ± 0.09 eV; and 4) we demonstrate that through the improvement of the fabrication process, it is possible to design devices with negligible trapping. Furthermore, the degradation of the samples was studied by means of step-stress experiments in off-state. Results indicate that exposure to moderate-high reverse bias (<; 250 V for LGD = 2 μm) does not induce any measurable degradation, thus confirming the high reliability of the analyzed samples. A permanent degradation is detected only for very high reverse voltages (typically, VDS = 260-265 V, on a device with LGD = 2 μm stressed with VGS = - 8 V) and consists of a rapid increase in gate leakage current, followed by a catastrophic failure. EL measurements and microscopy investigation revealed that degradation occurs close to the gate, in proximity of the sharp edges of the drain contacts, i.e., in a region where the electric field is maximum.
Sprache
Englisch
Identifikatoren
ISSN: 0885-8993
eISSN: 1941-0107
DOI: 10.1109/TPEL.2013.2271977
Titel-ID: cdi_proquest_journals_1490666522

Weiterführende Literatur

Empfehlungen zum selben Thema automatisch vorgeschlagen von bX