Details

Autor(en) / Beteiligte

• López-Marino, Simón
• Sánchez, Yudania
• Placidi, Marcel
• Fairbrother, Andrew
• Espindola-Rodríguez, Moisés
• Fontané, Xavier
• Izquierdo-Roca, Víctor
• López-García, Juan
• Calvo-Barrio, Lorenzo
• Pérez-Rodríguez, Alejandro
• Saucedo, Edgardo

Titel

ZnSe Etching of Zn-Rich Cu2ZnSnSe4: An Oxidation Route for Improved Solar-Cell Efficiency

Ist Teil von

• Chemistry : a European journal, 2013-10, Vol.19 (44), p.14814-14822

Ort / Verlag

Weinheim: WILEY-VCH Verlag

Erscheinungsjahr

2013

Quelle

Access via Wiley Online Library

Beschreibungen/Notizen

• Cu2ZnSnSe4 kesterite compounds are some of the most promising materials for low‐cost thin‐film photovoltaics. However, the synthesis of absorbers for high‐performing devices is still a complex issue. So far, the best devices rely on absorbers grown in a Zn‐rich and Cu‐poor environment. These off‐stoichiometric conditions favor the presence of a ZnSe secondary phase, which has been proved to be highly detrimental for device performance. Therefore, an effective method for the selective removal of this phase is important. Previous attempts to remove this phase by using acidic etching or highly toxic organic compounds have been reported but so far with moderate impact on device performance. Herein, a new oxidizing route to ensure efficient removal of ZnSe is presented based on treatment with a mixture of an oxidizing agent and a mineral acid followed by treatment in an aqueous Na2S solution. Three different oxidizing agents were tested: H2O2, KMnO4, and K2Cr2O7, combined with different concentrations of H2SO4. With all of these agents Se2− from the ZnSe surface phase is selectively oxidized to Se0, forming an elemental Se phase, which is removed with the subsequent etching in Na2S. Using KMnO4 in a H2SO4‐based medium, a large improvement on the conversion efficiency of the devices is observed, related to an improvement of all the optoelectronic parameters of the cells. Improvement of short‐circuit current density (Jsc) and series resistance is directly related to the selective etching of the ZnSe surface phase, which has a demonstrated current‐blocking effect. In addition, a significant improvement of open‐circuit voltage (Voc), shunt resistance (Rsh), and fill factor (FF) are attributed to a passivation effect of the kesterite absorber surface resulting from the chemical processes, an effect that likely leads to a reduction of nonradiative‐recombination states density and a subsequent improvement of the p–n junction. Se‐rich kesterites are highly promising materials for low‐cost thin‐film photovoltaics and are usually grown under Zn‐rich and Cu‐poor conditions. Although these conditions lead to the presence of a ZnSe secondary phase, which is detrimental for device performance, the phase can be selectively and oxidatively removed by treating the material with KMnO4 in H2SO4 followed by aqueous Na2S (see graphic).