Details

Autor(en) / Beteiligte

• Linke, Markus
• Flügge, Felix
• Olivares-Ferrer, Aurelio Jose

Titel

Design and Validation of a Modified Compression-After-Impact Testing Device for Thin-Walled Composite Plates

Ist Teil von

• Journal of composites science, 2020, Vol.4 (3), p.126

Ort / Verlag

Basel: MDPI AG

Erscheinungsjahr

2020

Link zum Volltext

Quelle

EZB Electronic Journals Library

Beschreibungen/Notizen

• Thin-walled fibre reinforced composites like carbon fibre reinforced plastics are very susceptible to strength reductions due to low-velocity impact damages. In aerospace engineering, the dominating failure mechanisms of impact damaged composite structures are usually investigated based on the compression after impact (CAI) test procedure. This enables the determination of the influence of impact damages on the static residual compressive strength. CAI testing procedures are typically applicable to composite plates with thicknesses larger than 3–4 mm. If thinner panels are used, they typically fail near one of the loaded edges of the CAI device, in particular the area of the free edge (which is needed for compressing the panel) and not within the free measuring area. As a consequence, the investigated samples cannot be used as valid tests for the evaluation of the residual strength in CAI testing. In order to enable an investigation of the residual strength of thin-walled plates in CAI testing, a CAI testing device is developed based on an available CAI fixture and a standardized one. For comparability reasons, this new device exhibits the same dimensions as standardized fixtures. It shows a significant improvement with respect to standardized devices concerning the measurement of mechanical behaviour during CAI testing.