Sie befinden Sich nicht im Netzwerk der Universität Paderborn. Der Zugriff auf elektronische Ressourcen ist gegebenenfalls nur via VPN oder Shibboleth (DFN-AAI) möglich. mehr Informationen...
•Effects of ammonia ratio and injection timing were explored in a RCCI engine.•More ammonia addition competed OH radicals with PODE, causing later a ignition timing.•More ammonia ratio increased ITE at the cost of higher HC, CO, and NH3 emissions.•NOx decreased with the larger AER due to enhanced thermal denitrification reactions.•Retarding injection timing reduced ITE and increased NOx emissions.
The application of ammonia as an alternative carbon-free fuel has attracted increasing attention. In this paper, the effects and mechanisms of ammonia energy ratio (AER) and polyoxymethylene dimethyl ethers (PODE) injection timing on the combustion and emissions characteristics of a PODE/ammonia RCCI engine are investigated by both experimental and numerical methods. Results show that increasing AER from 10% to 40% leads to the delayed low temperature heat release (LTHR) due to reduced OH radical generated by PODE and the competition between PODE and ammonia for OH radical consumption. The larger AER increases the indicated thermal efficiency (ITE) by lowering combustion temperature and reducing heat transfer losses at the cost of higher hydrocarbon (HC), carbon monoxide (CO), and unburned NH3 emissions. The reduction of fuel-based nitrogen oxide (NOx) emissions with a larger AER is attributed to the enhanced in-cylinder thermal denitrification reactions. The delayed start of injection (SOI) from −60 °CA ATDC to −45 °CA ATDC leads to the higher peak in-cylinder pressure and temperature, resulting in the larger heat transfer losses and lower ITE. The impact of retarding SOI on NOx is insignificant under the combined effect of more thermal NO formation, less fuel-based NO generation, and weakened denitrification reactions. Additionally, nitrous oxide (N2O) shows dominant effects on the total greenhouse gas (GHG) emissions, and increasing AER or advancing injection timing produces more GHG. Under low loads and low AERs, although the introduction of ammonia helps to improve ITE, more researches are required to further reduce exhaust emissions.